DataComm Home Command Center II User Manual

DataComm Electronics, Inc.
6349 Peachtree Street

Norcross, GA 30071-1725

888.223.7977

770.662.8205
www.datacommelectronics.com

Instruction / Installation Sheet

DataComm Electronics Home Command Center II 70-0050

Step 1 Installation of Back Panel

 Place plate with telephone 110 IDC on wall location and trace openings

for cut outs on wall. Remove plate and make cut outs for cables. Pull
telephone and televisioncables through cut outs in the wall.

 Pull cables through back of plate 70-0050 module plate and secure plate

to wall using mounting holes provided on the plate.

Step 2 Telephone

 Install the wire from the telephone demarcation point to the 110 IDC

marked from Telco.

 Install the twisted pair cables from each location in the house to the

remaining 110 IDC connectors. Match the color-coding of the wires to the
colors on the 110 IDC connectors. Incoming phone service can betested
using the test port.

 All cables should be punched down, using an industry standard punch-

down tool, to the 110 IDC connectors following the T568A wiring
configuration as shown below.

 Line 1 is Blue, Line 2 is Orange, Line3 is Green and Line 4 is Brown.

White / Bl ue
Blue

White / Orange
Orange

White / Green

Green
White / Brown
Brown

Step 3 Video

 Attach a male F-connector onto the cable TV service or satellite service

incoming cable. Screw the incoming cable with F-connector to the
connector marked input.

 Using F-connectors, terminate all coaxial leads that have been pulled

through the cut outs in the wall to the remaining connectors on the
splitter.

 Secure the cover of the 70-0050 module to the back panel and tighten

screws located at the bottom of the back plate of the module.

INSTRUCTIONS ARE CONTINUED ON THE BACK SIDE OF THIS PAGE

2/25/08 Rev. 1

Instruction / Installation Sheet

ETL LISTED

DataComm Electronics Home Command Center II 70-0050

CAUTION

 Never install telephone wiring during lighting storms.
 Never install telephone jacks in wet locations unless the jack is

specifically designed for wet locations.

 Never touch un-insulated wires or terminals unless the telephone

line has been disconnected at the network interface.

 Use caution when installing or modifying telephone lines.

IMPORTANT INSTRUCTIONS

 Read and understand all instructions.
 Follow all warnings and instructions marked on the product.

 Do not use this product near water, for example neara bath tub,

wash bowl, kitchen sink, or laundry tub, in a wet basement, or near a
swimming pool.

 SAVE THESE INSTRUCTIONS.

ONLY LICENSED PROFESSIONALS SHOULD INSTALL THIS PRODUCT

CONFORMS TO

UL STD 1863

ANSI/UL STD 60950-1

3026001

CAN/CSA STD C22.2 NO 60950-1

CERTIFIED TO

2/25/08 Rev. 1