Page 1
DataComm Electronics, Inc.
6349 Peachtree Street
Norcross, GA 30071-1725
888.223.7977
www.DataCommElectronics.com
770.662.8205
Instruction / Installation Sheet
1 & 2-Gang Low Voltage Mounting Brackets
Part # 60-0021-S & 60-0022-S
• This product is designed for use with low voltage cables ONLY.
• DO NOT run or pull a TV cord or other electrical cords inside the wall.
• It is a violation of the National Electric Code (NEC) to run power cords or
extension cords behind the wall.
Tools Needed
Pencil
Drywall Saw or Utility Knife
Philips Head Screw Driver
Installation
• Hold the low voltage mounting bracket with the face against the wall in your desired location.
• Use pencil and trace the two flat sides of the bracket (see fig. 1)
• Rotate the bracket 180º, aligning start and end points from your first mark and repeat
previous step (see fig. 2)
• Cut along the traced line with a drywall saw or utility knife.
• Insert low voltage mounting bracket into opening. Tighten down each of the screws. As
the wings tighten they will catch the back of the drywall, securing the plate in place.
• Install any standard low voltage single or dual gang wall plate to the bracket.
g. 1 g. 2
Caution:
• Never install low voltage wiring during lighting storms.
• Never touch un-insulated wires or terminals unless the wire has been disconnected at
its network interface.
• Use caution when installing or modifying data or telecommunication lines.
• DO NOT alter, change, or disconnect existing telecommunication wires if you are
unsure of their purpose or function.
• It is NOT recommended to install this product in close proximity to an electrical service
panel to prevent interference from electrical current.
Important Instructions:
• Read and understand all instructions.
• Do not use this product near water, for example near bath tub, wash bowl, kitchen,
sink, or laundry tub, in a wet basement, or near a swimming pool.
• SAVE THESE INSTRUCTIONS.
*1-Gang Model Shown
Loading...