DataComm 8 Port Passive Data Module for Cat 5e User Manual

DataComm Electronics, Inc.

ETL LISTED

6349 Peachtree St.
Norcross, GA 30071-1725

888.223.7977

770.662.8205
www.datacommelectronics.com

Instruction / Installation Sheet

DataComm Electronics 8-Port Passive Data Module 70-0030

Installation

 Align the mounting pins with holes in the back of the HCC panel and lock

module into place.

 Pull the Cat 5 or higher rated cables into the HCC panel from one of the

side knockouts.

 InstallCat 5 or higher rated cables from each location in the house to the

8-port passive data module. Match the color-coding of the wires to the
colors on the 110 IDC connectors.

 The wires should be punched down, using an industry standard punch-

down tool, to the 110 IDC connectors following the T568A wiring
configuration as shown below.

CAUTION

 Never install telephone wiring during lighting storms.
 Never install telephone jacks in wet locations unless the jack is

specifically designed for wet locations.

 Never touch un-insulated wires or terminals unless the telephone

line has been disconnected at the network interface.

 Use caution when installing or modifying telephone lines.

IMPORTANT INSTRUCTIONS

 Read and understand all instructions.
 Follow all warning and instructions marked on the product.

 Do not use this product near water, for example near bath tub, wash

bowl, kitchen sink, or laundry tub, in a wet basement, or near a
swimming pool.

 SAVE THESE INSTRUCTIONS.

White / Blue
Blue

White / Orange
Orange

White / Green

Green
White / Brown

Brown

ONLY LICENSED PROFESSIONALS SHOULD INSTALL THIS PRODUCT

CONFORMS TO

UL STD 1863

ANSI/UL STD 60950-1

3026001

CAN/CSA STD C22.2 NO 60950-1

CERTIFIED TO

10/5/07 Rev. 1