DataComm 70-0020 User Manual

DataComm Electronics, Inc.
6349 Peachtree Street
Norcross, GA 30071-1725

888.223.7977

770.662.8205
www.datacommelectronics.com

Instruction / Installation Sheet

DataComm Electronics Phone/Video Module 70-0020

1x8 Coax 4x10 Phone Module

Step 1 Video

 Attach a female F-connector onto the cable TV service or satellite service

incoming cable.

 Screw the incoming cable with F-connector to the connector marked

“input”.

 Using F-connectors, terminate all coaxial leads that have been pulled

through the top knockout to the video splitter.

 Align the four mounting pins with holes in the back of the panel (upper

most position recommended) and snap into place.

Step 2 Telephone

 Pull the telephone wires into the HCC panel from one of the side
 Install the cable from the telephone company demarcation point to the
 Install the twisted pair cables from each location in the house to the

 The wires should be punched down, using an industry standard punch-

 Line 1 is Blue, Line 2 is Orange, Line 3 is Green and Line 4 is Brown.
 A RJ31X port is provided for line 1 seizure by security system.

knockouts.
110 IDC marked from Telco.
remaining 110 IDC connectors. Match the color-coding of the wires to the

colors on the 110 IDC connectors.
down tool, to the 110 IDC connectors following the T568A wiring

configuration as shown below.

White / Blue
Blue

White / Orange
Orange

Wh ite / Green

Green
White / Brown
Brown

INSTRUCTIONS ARE CONTINUED ON THE BACK SIDE OF THIS PAGE

3/13/08 Rev. 1

Instruction / Installation Sheet

DataComm Electronics Phone/Video Module 70-0020

1x8 Coax 4x10 Phone Module

CAUTION

IMPORTANT INSTRUCTIONS

ONLY LICENSED PROFESSIONALS SHOULD INSTALL THIS PRODUCT

 Never install telephone wiring during lighting storms.
 Never install telephone jacks in wet locations unless the jack is

specifically designed for wet locations.

 Never touch un-insulated wires or terminals unless the telephone

line has been disconnected at the network interface.

 Use caution when installing or modifying telephone lines.

 Read and understand all instructions.
 Follow all warnings and instructions marked on the product.
 Do not use this product near water, for example a near bath tub,

wash bowl, kitchen sink, or laundry tub, in a wet basement, or near a
swimming pool.

 SAVE THESE INSTRUCTIONS.

ETL LISTED

CONFORMS TO

UL STD 1863

3026001

ANSI/UL STD 60950-1

CERTIFIED TO

CAN/CSA STD C22.2 NO 60950-1

3/13/08 Rev. 1