Page 1
DataComm Electronics, Inc.
www.datacommelectronics.com
6349 Peachtree St.
Norcross, GA 30071-1725
888.223.7977
770.662.8205
DataComm Electronics 4x6 Phone Module with
Step 1
Align the mounting pins with holes in the back of the HCC panel and lock
module into place.
Pull the Cat 5 or higher rated cables into the HCC panel from one of the
side knockouts.
InstallCat 5 or higher rated cables from each location in the house to the
8-port passive data module. Match the color-coding of the wires to the
colors on the 110 IDC connectors.
The wires should be punched down, using an industry standard punch-
down tool, to the 110 IDC connectors following the T568A wiring
configuration as shown below.
Instruction / Installation Sheet
4 Port Passive Data 70-0023
Step 2 Telephone
Pull the telephone wires into the HCC panel fromone of the side
knockouts.
Install the cable from the telephone company demarcation point to the
110 IDCmarked from Telco.
Install the twisted pair cables from each location in the house to the
remaining 110 IDC connectors. Match the color-coding of the wires to the
colors on the 110 IDC connectors.
The wires should be punched down, using an industry standard punch-
down tool, to the 110 IDC connectors following the T568A wiring
configuration as shown below.
Line 1 is Blue, Line 2 is Orange, Line 3 is Green and Line 4 is Brown.
A RJ31X port is provided for line 1 seizure by security system.
White / Blue
Blue
White / Orange
Orange
White / Green
Green
White / Brown
Brown
INSTRUCTIONS ARE CONTINUED ON THE BACK SIDE OF THIS PAGE
3/13/08
Page 2
Instruction / Installation Sheet
ETL LISTED
DataComm Electronics 4x6 Phone Module with
4 Port Passive Data 70-0023
CAUTION
Never install telephone wiring during lighting storms.
Never install telephone jacks in wet locations unless the jack is
specifically designed for wet locations.
Never touch un-insulated wires or terminals unless the telephone
line has been disconnected at the network interface.
Use caution when installing or modifying telephone lines.
IMPORTANT INSTRUCTIONS
Read and understand all instructions.
Follow all warnings and instructions marked on the product.
Do not use this product near water, for example near a bath tub,
wash bowl, kitchen sink, or laundry tub, in a wet basement, or near a
swimming pool.
SAVE THESE INSTRUCTIONS.
ONLY LICENSED PROFESSIONALS SHOULD INSTALL THIS PRODUCT
CONFORMS TO
UL STD 1863
3026001
ANSI/UL STD 60950-1
CERTIFIED TO
CAN/CSA STD C22.2 NO 60 950-1
3/13/08
Loading...