DataComm 4 x 16 RJ45 Phone Module User Manual

DataComm Electronics, Inc.
6349 Peachtree Street

Norcross, GA 30071-1725

888.223.7977

770.662.8205
www.datacommelectronics.com

DataComm Electronics RJ45 Telephone Module 70-0026

Step 1

 Pull the telephone wires into the HCC panel fromtop or one of the side

knockouts.

 Using the black push pins, install the 70-0026 RJ45 telephone module in the

HCC panel. Install the cable from the telephone company demarcation point to
the 110 IDC marked from Telco. This will activate line 1, line 2, line 3 and line 4

on the RJ45 ports.

 The wires should be punched down, using an industry standard punch-down tool,

to the 110 IDC connectors following the T568A wiring configuration as shown
below.

 Line 1 is Blue, Line 2 is Orange, Line 3 is Green and Line 4 is Brown.
 A RJ31X port is provided for line 1 seizure by security system.

Instruction / Installation Sheet

Step 2

 Install RJ45 plugs (purchased separately – DCE part #20-5703) on all Cat 5e

wiring home runs to the HCC panel.

 Be sure to wire the RJ45 plugs per the RJ45 plug instructions. Mis-wired RJ45

plugs will create a short or no dial tone.

 Once all RJ45 plugs are installed on the home runs, determine which telephone

jacks in the house will be line 1. To connect line 1, insert the RJ45 plug on the
Cat 5e home run into RJ45 ports labeled line 1 on the telephone module. Each

of these home runs will now be connected to line 1.

 To connect line 2, use same instruction as line 1 and use line 2 labeled RJ45

ports.

 To connect line 3, use same instruction as line 1 and use line 3 labeled RJ45

port.

 To connect line 4, use same instruction as line 1 and use line 4 labeled RJ45

port.

White / Blue
Blue

White / Orange
Orange

White / Green

Green
White / Brown

Brown

INSTRUCTIONS ARE CONTINUED ON THE BACK SIDE OF THIS PAGE

10/11/07 Rev. 2

Instruction / Installation Sheet

ETL LISTED

DataComm Electronics RJ45 Telephone Module 70-0026

CAUTION

 Never install telephone wiring during lighting storms.
 Never install telephone jacks in wet locations unless the jack is specifically

designed for wet locations.

 Never touch un-insulated wires or terminals unless the telephone line has

been disconnected at the network interface.

 Use Caution when installing or modifying telephone lines.

IMPORTANT INSTRUCTIONS

 Read and understand all instructions.
 Follow all warning and instructions marked on the product.

 Do not use this product near water, for example near bath tub, wash bowl,

kitchen sink, or laundry tub, in a wet basement, or near a swimming pool.

 SAVE THESE INSTRUCTIONS.

ONLY LICENSED PROFESSIONALS SHOULD INSTALL THIS PRODUCT

3026001

CONFORMS TO

UL STD 1863

ANSI/UL STD 60950-1

CERTIFIED TO

CAN/CSA STD C22.2 NO 60950-1

10/11/07 Rev. 2