DataComm 4 Gang 110 Phone Plate with Video Distribution User Manual

DataComm Electronics, Inc.
6349 Peachtree Street

Norcross, GA 30071-1725

888.223.7977

770.662.8205
www.datacommelectronics.com

Instruction/ Installation Sheet

DataComm Electronics 4-Gang 110 4x8 Phone Plate &

1x6 Splitter with Tester 70-0078

Telephone Installation

 Locate the central point where all telephone home runs meet.
 Install either a 4-gang mounting bracket or a 4 gang switch box at the central

point where the telephone wires come together.

 Installthe cable from the telephone company demarcation point to the top 110

IDC on the plate.

 Install the remaining twisted pair cables from each location in the house to the

remaining 110 IDC connectors. Match the color-coding of the wires to the colors
on the 110 IDC connectors. To connect phone service, insert the three inch

patch cord into the Telco port and the Home port. Incoming service can be tested
using the Telco port.

 The wires should be punched down, using an industry standard punch-down tool,

to the 110 IDC connectors following the T568A wiring configuration as shown
below.

 Secure the plate to either the mounting bracket or switch box.
 Line 1 is Blue, Line 2 is Orange, Line 3 is Green and Line 4 is Brown.

White / Blue
Blue

White / Orange
Orange

White / Green

Green
White / Brown

Brown

Video Installation

 Attach a male F-connector onto the cable TV service or satellite service incoming

cable. Screw the incoming cable with F-connector to the connector marked
input.

 Using F-connectors, terminate all coaxial leads that have been pulled through the

four gang in the wall to the remaining connectors on the splitter.

INSTRUCTIONS ARE CONTINUED ON THE BACK SIDE OF THIS PAGE

3/13/08 Rev. 1

Instruction/ Installation Sheet

ETL LISTED

DataComm Electronics 4-Gang 110 4x8 Phone Plate &

1x6 Splitter with Tester 70-0078

CAUTION

 Never install telephone wiring during lighting storms.
 Never install telephone jacks in wet locations unless the jack is

specifically designed for wet locations.

 Never touch un-insulated wires or terminals unless the telephone

line has been disconnected at the network interface.

 Use caution when installing or modifying telephone lines.

IMPORTANT INSTRUCTIONS

 Read and understand all instructions.
 Follow all warnings and instructions marked on the product.

 Do not use this product near water, for example near a bath tub,

wash bowl, kitchen sink, or laundry tub, in a wet basement, or near a
swimming pool.

 SAVE THESE INSTRUCTIONS.

ONLY LICENSED PROFESSIONALS SHOULD INSTALL THIS PRODUCT

3026001

CONFORMS TO

UL STD 1863

ANSI/UL STD 60950-1

CERTIFIED TO

CAN/CSA STD C22.2 NO 60950-1

3/13/08 Rev. 1