DataComm 45-0016 User Manual

DataComm Electronics, Inc.
6349 Peachtree Street
Norcross, GA 30071-1725
888.223.7977
www.DataCommElectronics.com
770.662.8205
Instruction / Installation Sheet Décor Insert with Flexible Opening Part # 45-0016
Use the Décor Insert with Flexible Opening to install low voltage cables behind your HDTV, amplifier or other audio video devices. The Décor Insert with Flexible Opening is designed to be installed onto a low voltage mounting bracket (sold separately) that is installed into the wall.
• This product is designed for use with low
voltage cable ONLY.
• DO NOT run or pull a TV cord or other
electrical cords inside the wall.
• It is a violation of the National Electric Code
(NEC) to run power cords or extension cords behind the wall.
Tools Needed
Philips Head Screw Driver
Installation
2. Run up to 4 (four) low voltage A/V cables through the opening in the low voltage mounting bracket, and then through the opening of the Décor Insert.
3. Place the Décor Insert against the low voltage mounting bracket. Using the two (2) included screws, screw the Décor Insert into place on the low-voltage mounting bracket.
4. To give your installation a finished look, install a décor wallplate (sold separately) over the Décor Insert.
Caution:
• Never install low voltage wiring during lighting storms.
• Never touch un-insulated wires or terminals unless the wire has been disconnected at
its network interface.
• Use caution when installing or modifying data or telecommunication lines.
• DO NOT alter, change, or disconnect existing telecommunication wires if you are
unsure of their purpose or function.
• It is NOT recommended to install this product in close proximity to an electrical service
panel to prevent interference from electrical current.
Important Instructions:
• Read and understand all instructions.
• Do not use this product near water, for example near bath tub, wash bowl, kitchen,
sink, or laundry tub, in a wet basement, or near a swimming pool.
• SAVE THESE INSTRUCTIONS.
This product is patent protected by U.S. Patent number 7495171.
RoHS Compliant
Loading...