DataComm 45-0006-BK Installation Manual

DataComm Electronics, Inc.

6349 Peachtree Street

Norcross, GA 30071-1725

888.223.7977

www.DataCommElectronics.com

770.662.8205

Instruction / Installation Sheet
1 3/4” Hole Saw Plate
Part # 45-0006-WH

• This product is designed for use with low voltage cables ONLY.

• DO NOT run or pull a TV cord or other electrical cords inside the wall.

• It is a violation of the National Electric Code (NEC) to run power cords or
extension cords behind the wall.

Tools Needed

Philips Head Screw Driver
1 3/4” Hole Saw

Installation

• First determine the location for the Hole Saw Brush Plate

• Now use a 1 3/4” hole saw to make the cut.

• Run low voltage A/V cables through the opening in the wall and through the Hole Saw Plate.

• Place the Hole Saw Plate into the cutout.

• Secure the plate to the wall by tightening down the screws with wings (do not over-tighten).

Caution:

• Never install low voltage wiring during lighting storms.

• Never touch un-insulated wires or terminals unless the wire has been disconnected at
its network interface.

• Use caution when installing or modifying data or telecommunication lines.

• DO NOT alter, change, or disconnect existing telecommunication wires if you are
unsure of their purpose or function.

• It is NOT recommended to install this product in close proximity to an electrical service
panel to prevent interference from electrical current.

Important Instructions:

• Read and understand all instructions.

• Do not use this product near water, for example near bath tub, wash bowl, kitchen,
sink, or laundry tub, in a wet basement, or near a swimming pool.

• SAVE THESE INSTRUCTIONS.

3026001

Drywall

Patent Pending