DataComm 1X6 Coaxial 4X6 Phone Module User Manual

DataComm Electronics, Inc.
6349 Peachtree Street

Norcross, GA 30071-1725

888.223.7977

770.662.8205
www.datacommelectronics.com

Instruction / Installation Sheet

DataComm Electronics Phone/Video Module 70-0021

Step 1 Video

 Attach a female F-connector onto the cableTV service or satellite service

incoming cable.

 Screw the incoming cablewith F-connector to the connector marked

“input”.

 Using F-connectors, terminate all coaxial leads that have been pulled

through the top knockout to the video splitter.

 Align the four mounting pins with holes in the back of the panel (upper

most position recommended) andsnap into place.

1x6 Coax 4x6 Phone Module

Step 2 Telephone

 Pull the telephone wires into the HCC panel from one of the side

knockouts.

 Install the cable from the telephone company demarcation point to the

110 IDC marked from Telco.

 Install the twisted pair cables from each location in the house to the

remaining 110 IDC connectors. Match the color-coding of the wires to the
colors on the 110 IDC connectors.

 The wires should be punched down, using an industry standard punch-

down tool, to the 110 IDC connectors following the T568A wiring
configuration as shown below.

 Line 1 is Blue, Line 2 is Orange, Line 3 is Green and Line 4 is Brown.
 A RJ31X port is provided for line 1 seizure by security system.

White / Blue
Blue

White / Orange
Orange

White / Green

Green
White / Brown
Brown

INSTRUCTIONS ARE CONTINUED ON THE BACK SIDE OF THIS PAGE

3/13/08 Rev. 1

Instruction / Installation Sheet

ETL LISTED

DataComm Electronics Phone/Video Module 70-0021

1x6 Coax 4x6 Phone Module

CAUTION

 Never install telephone wiring during lighting storms.
 Never install telephone jacks in wet locations unless the jack is

specifically designed for wet locations.

 Never touch un-insulated wires or terminals unless the telephone

line has been disconnected at the network interface.

 Use caution when installing or modifying telephone lines.

IMPORTANT INSTRUCTIONS

 Read and understand all instructions.
 Follow all warnings and instructions marked on the product.

 Do not use this product near water, for example near a bath tub,

wash bowl, kitchen sink, or laundry tub, in a wet basement or near a
swimming pool.

 SAVE THESE INSTRUCTIONS.

ONLY LICENSED PROFESSIONALS SHOULD INSTALL THIS PRODUCT

CONFORMS TO

UL STD 1863

3026001

ANSI/UL STD 60950-1

CERTIFIED TO

CAN/CSA STD C22.2 NO 60 950-1

3/13/08 Rev. 1