DataComm 10 Port Phone Module User Manual

DataComm Electronics, Inc.
6349 Peachtree Street

Norcross, GA 30071-1725

888.223.7977

770.662.8205
www.datacommelectronics.com

Instruction / Installation Sheet

DataComm Electronics 10 Port 110 Style Punch-Down Telephone Module 70-0070

Installation

 Align the mounting pins with holes in the back of the HCC panel and lock module into

place.

 Install the cable from the telephone company demarcation point to the 110 IDC connector

marked from Telco.

 Install twisted pair cables from each location in the house to the remaining 110 IDC

connectors. Match the color-coding of the wires to the colors on the 110 IDC connectors.

 The wires should be punched down, using an industry standard punch-down tool, to the

110 IDC connectors following the T568A wiring configuration as shown below.

 The RJ31x port is used to install the security line.
 Line 1 is Blue, Line 2 is Orange, Line 3 is Green and Line 4 is Brown.

CAUTION

 Never install telephone wiring during lighting storms.
 Never install telephone jacks in wet locations unless the jack is specifically

designed for wet locations.

 Never touch un-insulated wires or terminals unless the telephone line has been

disconnected at the network interface.

 Use caution when installing or modifying telephone lines.

IMPORTANT INSTRUCTIONS

 Read and understand all instructions.
 Follow all warnings and instructions marked on the product.

 Do not use this product near water, for example near a bath tub, wash bowl,

kitchen sink, or laundry tub, in a wet basement, or near a swimming pool.

 SAVE THESE INSTRUCTIONS.

White / Blue
Blue

White / Orange
Orange

White / Green

Green
White / Brown
Brown

ONLY LICENSED PROFESSIONALS SHOULD INSTALL THIS PRODUCT

CONFORMS TO

UL STD 1863

3026001

ANSI/UL STD 60950-1

CERTIFIED TO

CAN/CSA STD C22.2 NO 60950-1

2/25/08 Rev. 1