Wireless
Controller
For NintendoTMSNES
USER MANUAL
Package Content:
• SNES Wireless Controleller x
1
• Wireless Dongle x 1
• D-Pad Cover x 1
• User Manual x 1
Specification:
• Wireless controller (2.4GHz ) with range up to 20 ft
• Works with Nintendo SNES Classic Edition
• Turbo feature for 6 buttons
• Includes All-direction D-pad cover
L Button Turbo
Switch
R
Butto
n
Instructions:
1. Slide down the battery cover at the back of the
controller
D-Pad
SELECT
START
ABXY Buttons
D-Pad Cover
Wireless
Dongle
2.
Insert
two AAA batteries as indicated.
TURBO function:
3. Close the battery cover. The LED at the top of controller
will start slowly
flashing if the battery has been properly
connected.
4. Connect the Wireless Dongle to the front port of console
5.Holding both “A” and “B” button at the same time, until
the LED starts flashing quickly, will put the controller into
pairing mode. The LED will remain on when pairing is
successful.
6. Controller is now paired and ready to play.
Power Saving Mode:
This controller will enter into sleep mode after 3 minutes of
no use. Press any button to wake the controller.
This controller includes 6 TURBO switch for 6
buttons Each Switch has 3 options:
• AUTO: Turbo function always on
• TURBO: Turbo function on only with button press
• OFF: No Turbo function
D-Pad Cover:
Install the D-Pad cover to get all direction control.
FCC WARNING:
(1) This device may not cause harmful interference；
(2) this device must accept any interference received, including
This device complies with part 15 of the FCC Rules.Operation is subject
to the following two conditions:
interference that may cause undesired operation.
Any Changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to operate the
equipment.
Note: This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment
generates uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on,
the user is encouraged to try to correct the interference by one or more
of the following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help.
The device has been evaluated to meet general RF exposure
requirement. The device can be used in portable exposure condition
without restriction.
PRECAUTION AND MAINTENANCE
1. Please make sure there is no extreme pressure put on this
2. Don’t dismantle this product without permission.
3. This product should be situated away from heat sources
4. Keep this product dry and avoid any contact with damp or wet
areas.
product.
such as radiators and heaters.
Nintendo™ SNES is registered trademark or trademarks of Nintendo
Inc. All Rights reserved; All other trademarks are property of their
respective owners. Photos and illustrations not binding. Contents,
designs and specifications are subject to change without notice and
may vary from one country to another. This product is not distributed
under official license from or approved, sponsored or endorsed by
Nintendo Inc.
This product is not manufactured for
Nintendo Inc.
Loading...