Installation and User ManualInstallation and User Manual ver.1.0ver.1.0
[to integrate with the user manual of DAS M32/M44][to integrate with the user manual of DAS M32/M44]
Fiber OpticFiber Optic
Multiconn SrlMulticonn Srl
PORSCHE PCM3.0PORSCHE PCM3.0 –– PCM3.1PCM3.1
www.dasdvbt.comwww.dasdvbt.com
www.eldibg.com
car audio & multimedia system
Installation PCM3.0Installation PCM3.0-- PCM3.1:PCM3.1:
1. To install the DASDAS®®receiver, refer to the specific user manual;
Warning on the connection of the power supply cableWarning on the connection of the power supply cable::
- RED wire (fig.3) must beRED wire (fig.3) must be DISCONNECTEDDISCONNECTED..
The switch (ON/OFF) of the receiver will be controlled by the FiberThe switch (ON/OFF) of the receiver will be controlled by the Fiber--Optic activityOptic activity
- YELLOW wire (fig.1)(fig.1) must be connected to the +12V permanent/battery
- BLACK wire (fig.2)(fig.2) must be connected to the GND.
Power supply cable
11
22
33
Multiconn SrlMulticonn Srl
2
2. Disconnect the original Fiber Optical cable (fig.4)(fig.4) from the Head Unit and match it directly to DASDAS®®fiber optic female connector of the
harness on equipment (fig.5)(fig.5).
44
44 55
PCM3.0PCM3.0 –– PCM3.1PCM3.1
www.eldibg.com
car audio & multimedia system
3. Match the two other connectors of DASDAS®®harness (fig.6)(fig.6) respectively inside the original accessory (fig.7)(fig.7) and the other one inside DASDAS
®®
receiver (fig.8)(fig.8).
77
77 88
66
55
88
4. Connect one of the 3 DASDAS®®Video-OUT (fig.8)(fig.8) trough the adapter cables on equipment (fig.9) and the needed accessory(fig.9) and the needed accessory with white Fakra
connector (DCABMQS(DCABMQS--RCA in fig.9.1)RCA in fig.9.1) with the Video-IN on the Head Unit (fig.10)(fig.10).
Multiconn SrlMulticonn Srl
3
99
88
99.1.1
99
PCM3.0PCM3.0 –– PCM3.1PCM3.1
www.eldibg.com
car audio & multimedia system
Loading...