DAS HQ-218DX, HQ-218CX User Manual

» Direct radiator high power
subwoofer
» Dual 18" long excursion
neodymium speakers
» 2000 W RMS power
handling
» To be used in conjunction
The D.A.S. HQ-218 is a high-performance externally powered bass-reflex subwoofer system for use in active installed systems where bass reinforcement is required.
The HQ-218 system is intended as a flyable point source system where very high sound pressure levels are in order, such as indoor or outdoor sport venues, stadiums, arenas, etc. It can be flown in the same array in conjunction with other units as the HQ-112.43, HQ-
112.64 and HQ-112.95.
The system comprises one frequency section that is easily accessed through NL-4 connectors or covered barrier strip terminals.
The HQ-218 houses two D.A.S. 18LXN, 18” cone transducer configured as a direct radiators. This long excursion driver featuresa 4" edgewound coil, massive magnetstructure and carefully engineered cooling scheme, resulting in high power handling and low power compression.
The enclosure is manufactured from multi layer birch plywood and it is finished as a standard version (CX) with black ISO-flex polyurea paint. Totally exposed systems can be finished in fiber-glass. System IP rating is IP-54.
The cabinet includes 20 x M10 rigging points that are intended to fix stainless steel plates to create clusters.
HQ series
Dimensions
High efficiency Installation subwoofer
HQ-218
50 Hz - 125 Hz 2000 W 8000 W 101 dB SPL 140 dB SPL 2 x 18LX / GM 18 LX 4 ohms Trapezoidal Birch Plywood CX: Black ISO Flex Black Paint DX: Fiberglass/Military Grey Pantone 402C 20 x M10 threaded inserts 2 x NL-4 Covered Barrier Strip
98.7 x 67.9 x 71.5 cm
39.4 x 27.2 x 28.2 in 67 kg (147.4 lbs) ANL-2 - M10 Stainless steel rigging kit
Frequency Range (-10 dB) RMS (Average) Power Handling
(1)
Peak Power Handling On-Axis Sensitivity 1 W / 1 m Rated Maximum Peak SPL at 1 m
(2)
Transducers/Replacement Parts Nominal Impedance Enclosure Geometry Enclosure Material Color/Finish
Rigging Points Connectors
Dimensions (H x W x D)
Weight Accessories
Technical Specifications
1
Corresponds to the AES power handling rating for the component, based on a 2 hour test using a 6 dB cr est factor bandlimited pink noise signal.
2
Corresponds to the signal cr ests for the test described in1.
Frequency Response
Shows the frequency response at 1 m of a unit radiating to an anechoic environment and driven by a 2 V swept sine wave signal.
10 100 1k 10k 20k10 Hz
120.0
dBSPL
110.0
100.0
90.0
80.0
70.0
NOTES. 1.Frequency response: referred to 1 m; low end obtained thr ough the use of near field techniques; one-third octave smoothed for correlation with human hearing.
HQ-218
action series
Product improvement through r esearch and development is a continuous process at D.A.S. Audio. All specifications subject to change without notice.
18LX long-excursion low distortion loudspeaker
Loading...