Vintage Deluxe
The Deluxe is back with a vengeance
Smooth overdriven bass sounds, or warming the signal with
the Vintage Deluxe, it will give many alternatives to project a
concrete bottom end top lay any style you will prefer.
Warning
The Microtubes B7K has a current draw of 30mA. Only use a
regulated 9V DC adapter with a center-negative plug. Due to
ecological reasons it does not accept batteries. Unregulated
power supplies and/or higher voltages may result in suboptimal noise performance and even damage your unit, voiding
the warranty.
Warranty
To activate the warranty, we encourage you to register your
product on: http://mypedal.darkglass.com and enter the serial
number on the back of your pedal.
Please contact us via email support@darkglass.com before
shipping a product to us.
Controls
Blend: Mixes the clean input signal with the overdriven signal.
The clean signal remains at unity gain while the volume of the
overdriven signal is set by the Level knob, allowing for fine
control of the blend ratio.
Level: Sets the volume of the overdriven signal.
Drive: Sets the amount of saturation in the overdriven signal.
Grunt Switch: Sets the amount of low frequency content to
saturate by selecting between three different bass boost
levels before the clipping stage.
Attack Switch: Sets the amount of treble content to saturate:
The "Boost" setting emphasizes the treble content extra
clarity and presence. The "Flat" position leaves this register
untouched while the "Cut" position will reduce the amount of
high frequencies being saturated.
Low: +-12dB @ 100Hz | Low Mids: +-12dB @ 500Hz
Hi Mids: +-12dB @ 1.5 kHz | Treble: +-12dB @ 5kHz
Low Mids Switch: this switch change the center frequency of
the Low Mids from 1kHz to 500Hz.
Hi Mids Switch: this switch change the center frequency of
the Hi Mids from 3kHz to 1.5kHz.
Parallel Output: A passthrough for your input signal, useful
for parallel processing.
Direct Output: A balanced version of the ¼” output, useful for
running into PA’s or studio mixing console
Technical Specifications
Input Impedance 500k
Output Impedance 1k
Current Consumption ~20mA
Voltage 9V DC (Center Negative)
Dimensions
Width 106 mm (4.21 in)
Height 120 mm (4.72 in)
Depth 45 mm (1,77 in)
Weight 350 gr (0.78 lb)
Disclaimer
In the interest of continuous improvement, specifications are
subject to change without notice. If you have any questions,
please don’t hesitate to contact us at www.darkglass.com
The manufacturer claims that the above product fulfills the
requirements as set by EN55013, EN55020, EN60555-2,
EN60555-3, RoHS, WEEE.
EMC / EMI
This equipment has been tested and found to comply with
the limits for a Class B Digital device, pursuant to part 15 of
the FCC rules. These limits are designed to provide reasonable protection against harmful interference in residential
installations.
This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance
with the instructions, may cause harmful interference to radio
communications. There is no guarantee that interference will
not occur in a particular installation.
If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
· Reorient or relocate the receiving antenna.
· Increase the separation between the equipment and
receiver.
· Connect the equipment to an outlet on a circuit different from
that to which the receiver is connected.
· Consult the dealer or an experienced radio/TV technician for
help
Loading...