Microtubes X7
The Microtubes X series brings the studio method producers have been
using the years to cover the whole bass distortion spectrum: from articulate
high gain to punchy mild overdrive, raw and gnarly fuzz and everything in
between
You now have absolute control in constructing your vision of what the perfect
bass distortion texture, definition, and size should have
Controls
High Pass Frequency: controls the cutoff frequency to be distorted, ranging
from 100Hz (for thicker, fuzzier saturation) or 1kHz for ultra-sharp definition.
High Drive: Sets the amount of distortion for the high pass side.
High Level: Sets the output volume of the distorted high-pass signal.
Low Pass Frequency: controls the cutoff frequency to be mixed back to the
high-pass side. Ranging from 50Hz (for only sub-bass) and 500Hz to
preserve some clean mids.
Low Comp: Sets the amount of compression for the low-pass signal.
Low Level: Sets the output volume of the low-pass signal.
Master: Sets the overall volume of the unit.
Low shelf: +-12dB @ 80 Hz
500 Hz: +-12dB
1 kHz: +-12dB
High shelf: +-12dB @ 5 kHz
Warning
The Microtubes X7 has a current draw of 70mA. Only use a regulated 9V DC
adapter with a center-negative plug. Due to ecological reasons, it does not
accept batteries. Unregulated power supplies and/or higher voltages may
result in suboptimal noise performance and even damage your unit, voiding
the warranty.
Warranty
To activate the warranty, we encourage you to register your product on:
http://mypedal.darkglass.com and enter the serial number on the back of
your pedal.
Please contact us via email support@darkglass.com before shipping a
product to us.
Technical Specifications
Input Impedance 1MΩ
Output Impedance 1kΩ
Current Consumption 70mA
Voltage 9V DC (Center Negative)
Dimensions
Width 94 mm (3.70 in)
Height 120 mm (4.72 in)
Depth 46 mm (1.81 in)
Weight 320 g (0.70 lb)