Wireless Optical Mouse for Laptops
Quick Setup Guide
1. Left Mouse Button
2. Right Mouse Button
3. Scroll Wheel
4. Battery Cover
5. Smart Receiver Storage Compartment
6. Battery Cover Release Button
7. Wireless Receiver Eject Button
8. Mouse CONNECT Button
9. Wireless Receiver CONNECT Button
System requirements
IBM® compatible system or Macintosh®
Windows 98, 2000, Me, XP or Mac OS 10.0 or later
An available USB Port
Installation instruction
Battery installation
1. Press the 「Battery Cover Release Button」to remove the battery cover.
2. Install two AAA alkaline batteries in the mouse.
3. Slide and lock battery cover back in place.
Operating Instructions
1. Plug the wireless receiver into the USB port of your system (Your system will automatically
detect for new hardware).
2. To activate the mouse, please press and release the CONNECT button located on the
bottom of the mouse.
3. Press and release the CONNECT button on the wireless receiver. (Please make sure to
perform step 2 & 3 within 10 seconds of each other.) Repeat Step 2 & 3 if the mouse is not
activated.
4. Smart Receiver Storage & Manual Power Down
This Wireless Optical Mouse for Laptops automatically powers OFF when the wireless
receiver is stored in the Smart Receiver Storage Compartment. This feature will extend
the life of the battery and eliminate the chance of leaving the wireless receiver behind.
The mouse will automatically power ON when the wireless receiver is released from the
Smart Receiver Storage Compartment.
You can manually power the mouse OFF by pressing the Left and Right Mouse Buttons
and Scroll Wheel Button simultaneously. Press any mouse button to turn the power ON.
In order to further extend the battery life of your Wireless Optical Mouse for Laptops, the
mouse will automatically goes into sleep mode after 5 minutes if no activity or movement
is detected. To resume normal operation, either move the mouse or press any of the
mouse buttons.
5. To avoid damage during transportation, it is recommended to store your Wireless Optical
Mouse for Laptops in its Bonus Travel Pouch.
6. This Wireless Optical Mouse for Laptops can operate up to 4 feet (1.2 m) from the Wireless
Receiver.
When the mouse doesn’t work
Please check that the batteries are loaded correctly.
Please check if the wireless receiver is connected to the USB port correctly.
Please make sure the wireless mouse & receiver are connected properly by following
steps 2 & 3 of the Operating Instructions.
Please try to avoid operating the optical mouse on metallic or glass surfaces as the
optical sensor will not function correctly.
Loading...