Darfon Electronics H100 Users Manual

H100 Bluetooth Headset Instruction Manual
Contents
Introduction ---------------------------------------------------------- 2
Headset Features ---------------------------------------------------- 2

Turning on/off Headset----------------------------------------------------------------------- 2
Answering Calls ------------------------------------------------------------------------------- 3
Ending Calls------------------------------------------------------------------------------------ 3
Making Calls----------------------------------------------------------------------------------- 4
Adjusting the Volume ------------------------------------------------------------------------ 4
Mute Mode/Canceling Mute Mode-------------------------------------------------------- 4
Transferring Sound from Phone to Headset and Vice Versa ------------------------- 4

Lost Connection to Headset----------------------------------------------------------------- 4

Troubleshooting------------------------------------------------------ 5
Safety Acknowledgement and Warranty------------------------ 5
Warranty-------------------------------------------------------------- 5

1

Introduction

The H100 Bluetooth Headset provides you with the most advanced Bluetooth
technology for outstanding performance, comfort, simple operation interface and high
reliability of this product
Before using this product, please ensure that the devices are intended to be used with
the products that are compatible with Bluetooth specifications v1.1 or above and can
support the Headset profile.

The kit includes:

z H100 Bluetooth Headset
z H100 Ear Hook
z AC Power Charger

z Speaker protector

z Instruction Manual

Headset Features

About your Headset

Call Handling Button

Instructions for Operating Bluetooth Headset

Vol ume
Control

1. Turning on/off Headset

To turn on the Headset:

2

a. Press and hold the call handling button on the headset. The LED indicator will

flash with blue light 5 times.

b. The headset is in standby mode after being turned on. The LED indicator flashes

with blue light once every 3 seconds.

To turn off the Headset:
a. Press and hold the call handling button on the headset. The LED indicator will

flash with red light 5 times.

b. The headset is turned off and the LED indicator light is switched off.

Pairing the Headset with a Phone
Before using, you should pair the headset with Bluetooth devices, such as a Bluetooth
phone, a laptop computer or a PDA. After pairing, the two devices then recognize
each other and make wireless connection. Once you have paired your headset with
the Bluetooth device, you do not need to run the pairing process again. When the two
paired devices are turned on with Bluetooth function, the headset will connect to the
Bluetooth device automatically. When you want to use your headset together with
other Bluetooth mobile phones or other Bluetooth devices, perform the pairing steps.
Steps for pairing:

I. The headset must be powered off before initiating the pairing.
II. Ensure the mobile phone is turned on with Bluetooth devices

searching function activated (Please see details in the instruction
manual for the mobile phone).

III. Press and hold the call handling button until the LED indicator

flashes with red and blue lights alternatively. The phone is now
performing pairing.

IV. When the mobile phone has detected the headset, “H100” will

then appear in the display.

V. Accept pairing, and follow the instructions provided by the phone.

Enter the headset passkey 0000 when you are asked to do so.

VI. You should repeat the above steps if the devices cannot be paired

within 60 seconds (You may check the status on the phone
display).

VII. When pairing is finished, you will be notified that the pairing was

successful on the phone’s display and the LED indicator will flash
with blue light continuously. The headset will also go into
standby mode.

VIII. The headset is now ready for making or answering calls.
IX. When the Bluetooth is disconnected, not only will the headset

attempt to connect with the phone automatically, you may also
press the call handling button when the LED indicator light
flashes blue continuously (standby mode), so as to connect the
headset with the phone again manually.

Note: If the headset is not in pairing mode, your mobile phone won’t find the headset.
Please set the headset into pairing mode before letting your mobile phonesearch for
the headset.

3