Page 1
20" END TABLE
PARTS LIST
PART NO
01
13
03
07
22
FIGURE
DESCRIPTION QTY
Hardware Bag
Table Top
Drawer
Legs
Fixed Shelf
1 pce
1 pce
1 pce
4 pcs
1 pce
IMPORTANT NOTE : Please keep all hardware parts out of the reach of children.
03
13
07
22
Page 1 of 2
MADE IN MALAYSIA
Page 2
Reminders :
Two people are needed for assembly.
Use only hardware supplied.
Do not over tighten bolts.
This item may require periodic tightening.
HARDWARE PART :
20" END TABLE
Hex Bolt
8 pcs
Lock Washer
8 pcs
Flat Washer
8 pcs
Wrench
1 pc
Wood Knob
1 pc
Truss Head Screw
1 pc
ASSEMBLY :
STEP 1
Pull out the Drawer Box as shown and Turn the Table Top upside down on a protective surface such as carpet or other soft material.
Use Flat Washer, Lock Washer, Hex Bolt and Wrench, to attach three legs randomly to the table top, do not fully tighten yet. Insert
the fixed shelf into the legs as shown in the diagram, then install the fourth leg.
Flat Washer
Lock Washer
Hex Bolt
Wrench
STEP 2
Set the table upright on its legs. Then insert the Drawer Box to it's compartment. Unscrew the knob from the back of the drawer.
Then install the knob onto the front of the drawer, as shown in the diagram.
STEP 3
Check its balance and tighten all bolts to complete the assembly.
Wood Knob
Truss Head
Screw
Screw Driver
(Not provided)
CARE INSTRUCTION
~ Be sure to use the same type of polish consistenly.
Your furniture will appear cloudy or streaky if oil
based or wax based polishes are interchanged.
~ Spray your furniture surface evenly. Wipe in a
circular motion with a soft clean cloth.
Page 2 of 2
MADE IN MALAYSIA
Loading...