DAP Products 7079818370 User Manual

SDS Number: 00008675004 Revision Date: 7/28/2015

24 Hour Emergency Phone Numbers
Medical/Poison Control:
In U.S.: Call 1-800-222-1222

Outside U.S.: Call your local poison
control center

Transportation/National Response

Safety Data Sheet

IMPORTANT: Provide this information to employees, customers, and users of this product. Read this SDS before handling or disposing of this
product. This product is covered by the OSHA Hazard Communication Standard and this document has been prepared in accordance with
requirements of this standard. All abbreviated terms used in this MSDS are further described in Section 16.

Center:

1-800-535-5053
1-352-323-3500

NOTE: The National ResponseCenter emergency
numbers to be used only in the event of chemical
emergencies involving a spill, leak, fire, exposure or
accident involving chemicals.

1. Identification

This Material Safety Data Sheet is available in American Spanish upon request.

Los Datos de Serguridad del Producto pueden obtenerse en Espanol si lo riquiere.

Product Name: DAP Silicone Plus Concrete Gray Revision Date: 7/28/2015

Product UPC Number:

Product Use/Class: Caulking Compound

Manufacturer:

Preparer: Regulatory Department

070798086753

DAP Products Inc.
2400 Boston Street Suite 200
Baltimore, MD 21224-4723
888-327-8477 (non - emergency matters)

Supercedes Date:

SDS No: 00008675004

9/27/2011

2. Hazards Identification

EMERGENCY OVERVIEW: High concentration of vapors may cause irritation to eyes and respiratory system.

GHS Classification

Eye Irrit. 2, Skin Sens. 1, STOT RE 2

Symbol(s) of Product

Signal Word

Warning

GHS HAZARD STATEMENTS

Skin Sensitizer, category 1 H317 May cause an allergic skin reaction.

Eye Irritation, category 2 H319 Causes serious eye irritation.

Page 1 / 6

SDS Number: 00008675004 Revision Date: 7/28/2015

Silica, amorphous

2.5-10

GHS03-GHS07

H270-332

GHS03-GHS07­GHS08

Carbon black

0.1-1.0

No Information

No Information

Titanium dioxide

0.1-1.0

No Information

No Information

STOT, repeated exposure, category 2 H373 May cause damage to organs through prolonged or repeated exposure.

GHS LABEL PRECAUTIONARY STATEMENTS

P261 Avoid breathing dust/fume/gas/mist/vapours/spray.

P280 Wear protective gloves/protective clothing/eye protection/face protection.
P302+P352 IF ON SKIN: Wash with plenty of soap and water.

P333+P313 If skin irritation or rash occurs: Get medical advice/attention.

GHS SDS PRECAUTIONARY STATEMENTS

P363 Wash contaminated clothing before reuse.

3. Composition/Information on Ingredients

Chemical Name CAS-No. Wt. % GHS Symbols GHS Statements

7631-86-9

Methyltri(ethylmethylketoxime)silane 22984-54-9 2.5-10

1333-86-4
13463-67-7

The text for GHS Hazard Statements shown above (if any) is given in the "Other information" Section.

H270-317-319-373

4. First-aid Measures

FIRST AID - INHALATION: Material is not likely to present an inhalation hazard at ambient conditions. If you experience difficulty in

breathing, leave the area to obtain fresh air. If continued difficulty is experienced, get medical attention immediately.

FIRST AID - SKIN CONTACT: Wash skin with soap and water for 15 minutes. Get medical aid if symptoms persist.

FIRST AID - EYE CONTACT: In case of contact, immediately flush eyes with large quantities of water for at least 15 minutes until

irritation subsides. Get medical attention immediately.

FIRST AID - INGESTION: If swallowed, DO NOT INDUCE VOMITING. Get medical attention immediately.

5. Fire-fighting Measures

UNUSUAL FIRE AND EXPLOSION HAZARDS: None known.

SPECIAL FIREFIGHTING PROCEDURES: Wear self-contained breathing apparatus pressure-demand (NIOSH approved or

equivalent) and full protective gear. Use water spray to cool exposed surfaces.

EXTINGUISHING MEDIA: Alcohol Foam, Carbon Dioxide, Dry Chemical, Foam, Water Fog

6. Accidental Release Measures

ENVIRONMENTAL MEASURES: No Information

STEPS TO BE TAKEN IF MATERIAL IS RELEASED OR SPILLED: Contain spilled material and remove with inert absorbent.

Dispose of contaminated absorbent, container and unused contents in accordance with local, state and federal regulations. Scrape
up dried material and place into containers. Use personal protective equipment as necessary. In case of spillage, absorb with inert
material and dispose of in accordance with applicable regulations.

HANDLING: KEEP OUT OF REACH OF CHILDREN!DO NOT TAKE INTERNALLY. Avoid breathing vapor and contact with eyes,
skin and clothing. Use only with adequate ventilation. Wash thoroughly after handling. Remove contact lenses before using. Do
not handle contact lenses until all sealant has been cleaned from fingertips, nails and cuticles. Residual sealant may transfer to
contact lenses and cause severe eye irritation.

STORAGE: Avoid excessive heat and freezing. Do not store at temperatures above 120 degrees F. Store away from caustics and
oxidizers.

Page 2 / 6