DAP Products 7079800753, 7079808646, 7079808642, 7079808641, 7079808643 User Manual

SDS Number: 00008684001 Revision Date: 5/19/2015

Hydrotreated middle distillate

10-25

GHS06

H331

24 Hour Emergency Phone Numbers:

Medical/Poison Control:

In U.S.: Call 1-800-222-1222

Safety

Outside U.S.: Call your local poison
control center

Transportation/National Response
Center:

Data

NOTE: The National ResponseCenter
emergency numbers to be used only in the

Sheet

IMPORTANT: Provide this information to employees, customers, and users of this product. Read this SDS before handling or disposing of this
product. This product is covered by the OSHA Hazard Communication Standard and this document has been prepared in accordance with
requirements of this standard. All abbreviated terms used in this MSDS are further described in Section 16.

event of chemical emergencies involving a spill,
leak, fire, exposure or accident involving
chemicals.

1-800-535-5053
1-352-323-3500

1. Identification

This Material Safety Data Sheet is available in American Spanish upon request.

Los Datos de Serguridad del Producto pueden obtenerse en Espanol si lo riquiere.

Product Name: 100% Silicone Window & Door White Revision Date: 5/19/2015

Product UPC Number:

Product Use/Class: Caulking Compound

Manufacturer:

08646

DAP Products Inc.
2400 Boston Street Suite 200
Baltimore, MD 21224-4723
888-327-8477 (non-emergency matters)

Supercedes Date:

SDS No: 00008684001

No Information

Preparer: Regulatory Department

2. Hazards Identification

EMERGENCY OVERVIEW: Under normal use conditions, this product is not expected to cause adverse health effects. High

concentration of vapors may cause irritation to eyes and respiratory system.

GHS Classification

Not a hazardous substance or mixture.

Symbol(s) of Product

Not a hazardous substance or mixture.

Signal Word

Not a hazardous substance or mixture.

3. Composition/Information on Ingredients

Chemical Name CAS-No. Wt. % GHS Symbols GHS Statements

64742-46-7

Page 1 / 6

SDS Number: 00008684001 Revision Date: 5/19/2015

Silica, amorphous

2.5-10

GHS07

H332

Ethyltriacetoxysilane

2.5-10

GHS07

H302-312-315-319-332

Silanetriol, methyl-, triaceta

2.5-10

GHS07

H302-312-315-319-332

Titanium dioxide

0.1-1.0

No Information

No Information

7. Handling and Storage

7631-86-9
17689-77-9
4253-34-3
13463-67-7

The text for GHS Hazard Statements shown above (if any) is given in the "Other information" Section.

4. First-aid Measures

FIRST AID - INHALATION: Material is not likely to present an inhalation hazard at ambient conditions. If you experience difficulty in

breathing, leave the area to obtain fresh air. If continued difficulty is experienced, get medical attention immediately.

FIRST AID - SKIN CONTACT: Wash skin with soap and water for 15 minutes. Get medical aid if symptoms persist.

FIRST AID - EYE CONTACT: In case of contact, immediately flush eyes with large quantities of water for at least 15 minutes until

irritation subsides. Get medical attention immediately.

FIRST AID - INGESTION: If swallowed, DO NOT INDUCE VOMITING. Get medical attention immediately.

5. Fire-fighting Measures

UNUSUAL FIRE AND EXPLOSION HAZARDS: None known.

SPECIAL FIREFIGHTING PROCEDURES: Wear self-contained breathing apparatus pressure-demand (NIOSH approved or

equivalent) and full protective gear. Use water spray to cool exposed surfaces.

EXTINGUISHING MEDIA: Carbon Dioxide, Dry Chemical, Foam, Water Fog

6. Accidental Release Measures

ENVIRONMENTAL MEASURES: No Information

STEPS TO BE TAKEN IF MATERIAL IS RELEASED OR SPILLED: Contain spilled material and remove with inert absorbent.

Dispose of contaminated absorbent, container and unused contents in accordance with local, state and federal regulations. Scrape up
dried material and place into containers. Use personal protective equipment as necessary. In case of spillage, absorb with inert
material and dispose of in accordance with applicable regulations.

HANDLING: KEEP OUT OF REACH OF CHILDREN!DO NOT TAKE INTERNALLY. Avoid breathing vapor and contact with eyes,
skin and clothing. Use only with adequate ventilation. Ensure fresh air entry during application and drying. Wash thoroughly after
handling. Remove contact lenses before using. Do not handle contact lenses until all sealant has been cleaned from fingertips, nails
and cuticles. Residual sealant may transfer to contact lenses and cause severe eye irritation.

STORAGE: Avoid excessive heat and freezing. Do not store at temperatures above 120 degrees F. Store away from caustics and
oxidizers.

8. Exposure Controls/Personal Protection

Ingredients with Occupational Exposure Limits

Chemical Name ACGIH TLV-TWA ACGIH-TLV STEL OSHA PEL-TWA

OSHA PEL-CEILING

Hydrotreated middle distillate N.E. N.E. N.E. N.E.
Silica, amorphous N.E. N.E. N.E. N.E.
Ethyltriacetoxysilane N.E. N.E. N.E. N.E.
Silanetriol, methyl-, triaceta N.E. N.E. N.E. N.E.
Titanium dioxide 10 mg/m3 TWA N.E. 15 mg/m3 TWA

N.E.

total dust

Page 2 / 6