DAPAudio SPLASH 8, SPLASH 10, SPLASH 10A, SPLASH 12, SPLASH 8A User Manual
...
Ordercode:
D3588
D3589
D3590
D3591
D3494
D3595
D3592
D3593
Productname:
Splash 8A
Splash 10A
Splash 12A
Splash 15A
Splash 8
Splash 10
Splash 12
Splash 15
Splash Series Active / Passive
Highlite International B.V. – Vestastraat 2 – 6468 EX – Kerkrade – the Netherlands
MANUAL
ENGLISH
Splash Series Active / Passive
Ordercode: D3588 – D3595
Table of contents
Warning ............................................................................................................................................................................... 2
Unpacking Instructions ................................................................................................................................................. 2
Safety Instructions ......................................................................................................................................................... 2
Connection with the mains ......................................................................................................................................... 4
Return Procedure .......................................................................................................................................................... 4
Claims .............................................................................................................................................................................. 4
Features ............................................................................................................................................................................... 5
Panel Description Splash 8A/10A12A/15A ............................................................................................................... 6
Panel Description Splash 8/10/12/15 ......................................................................................................................... 7
Connection Example 8A/10A/12A/15A ................................................................................................................... 8
Connection Example 8/10/12/15 .............................................................................................................................. 9
Floor monitor setup .....................................................................................................................................................10
Connection Cables .........................................................................................................................................................11
Technical Specifications ................................................................................................................................................12
Splash 8A ......................................................................................................................................................................12
Splash 10A ....................................................................................................................................................................12
Splash 12A ....................................................................................................................................................................13
Splash 15A ....................................................................................................................................................................13
Splash 8 .........................................................................................................................................................................14
Splash 10 .......................................................................................................................................................................14
Splash 12 .......................................................................................................................................................................15
Splash 15 .......................................................................................................................................................................15
Frequency Response Diagram .....................................................................................................................................16
Troubleshooting................................................................................................................................................................18
Dimensions ........................................................................................................................................................................18
1
Splash Series Active / Passive
Ordercode: D3588 – D3595
FOR YOUR OWN SAFETY, PLEASE READ THIS USER MANUAL CAREFULLY
CAUTION! Be careful with your operations.
a dangerous electric shock when touching the wires!
Warning
Unpacking Instructions
Immediately upon receiving this product, carefully unpack the carton and check the contents to ensure
that all parts are present and have been received in good condition. Notify the dealer immediately and
retain packing material for inspection if any parts appear damaged from shipping or the carton itself
shows signs of mishandling. Save the carton and all packing materials. In the event that a fixture must be
returned to the factory, it is important that the fixture be returned in the original factory box and packing.
Safety Instructions
Every person involved with the installation, operation and maintenance of this device have to:
- be qualified
- follow the instructions of this manual
Before your initial start-up, please make sure that there is no damage caused by transportation. Should
there be any, consult your dealer and do not use the device.
To maintain perfect condition and to ensure a safe operation, it is absolutely necessary for the user to
follow the safety instructions and warning notes written in this manual.
Please consider that damages caused by manual modifications to the device are not subject to
warranty. This device contains no user-serviceable parts. Refer servicing to qualified technicians only.
IMPORTANT!
The manufacturer will not accept liability for any resulting damages caused by the nonobservance of this manual or any unauthorized modification to the system.
Always disconnect power from the mains, when system is not used. Only handle the power-cord by
the plug. Never pull out the plug by tugging the power-cord.
Always operate the unit with the AC ground wire connected to the electrical system ground.
Avoid flames and do not put close to flammable liquids or gases.
Avoid ground loops! Always be sure to connect the power amps and the mixing console to the
same electrical circuit to ensure the same phase!
Avoid installing your equipment very near radio or TV sets, mobile phones, etc., as these can cause
RF (radio frequency) interference.
Before changing your grounds around, always turn your amplifiers down.
Before connecting or disconnecting the power cord, make certain the ON / OFF switch is in the OFF
position.
Before switching on or off make certain the sound system’s amplifiers are off or turned down: this will
avoid signal peaks, which are annoying and sometimes dangerous (particularly for speaker
enclosures).
Do not connect (parallel or series) an amplifier output with any other amplifier output.
Do not connect this device to a dimmer pack.
Do not drive the inputs with a signal level bigger, than required to drive the equipment to full output.
BEFORE YOUR INITIAL START-UP!
With a dangerous voltage you can suffer
2
Splash Series Active / Passive
Ordercode: D3588 – D3595
Do not insert objects into air vents.
Do not open this device. Risk: hazardous radiation exposure.
Do not run the output of any amplifier channel, back into another channel’s input.
Do not switch the system on and off in short intervals, as this would reduce the system’s life.
Extreme frequency boosts in connection with a high input signal level may lead to overdriving your
equipment. Should this occur, it is necessary to reduce the input signal level by using the INPUT
control.
For replacement use fuses of same type and rating only.
If device is dropped or struck, disconnect mains power supply immediately. Have a qualified
engineer inspect for safety before operating.
If the system has been exposed to drastic temperature fluctuation (e.g. after transportation), do not
switch it on immediately. The arising condensation water might damage your system. Leave the
system switched off until it has reached room temperature.
In system setup, the amplifier's output power must be 50%-100% more than the loaded loudspeakers
rated power.
Keep this user’s manual for future consultation. Also remember that the crossover will get a better
price on the secondhand market if (as well as being in good condition) it has its original
documentation and packaging.
Make sure that the available voltage is not higher than stated on the rear panel.
Make sure that the power-cord is never crimped or damaged. Check the device and the power-
cord from time to time.
Make sure that the signals into the mixer are balanced, otherwise hum could be created.
Make sure that there is sufficient room on all sides of the system for air circulation.
Make sure you don’t use the wrong kind of cables or defective cables.
Make sure you use DI boxes to balance unbalanced signals; All incoming signals should be clear
Never let the power-cord come into contact with other cables! Handle the power-cord and all
connections with the mains with particular caution!
Never remove warning or informative labels from the unit.
Never use anything to cover the ground contact.
Only use device indoor, avoid contact with water or other liquids.
Please turn off the power switch, when changing the power cord or signal cable, or select the input
mode switch.
Prevent distortion! Make sure that all components connected to the DRX-Series have sufficient power
ratings. Otherwise distortion will be generated because the components are operated at their limits.
Repairs, servicing and electric connection must be carried out by a qualified technician.
Sometimes, when you want to send one signal to more than one amplifier, you should use a signal
distributor.
The best way (even if not always feasible) to avoid ground loops is to connect the electric ground of
all the equipment to a single central point (“star” system). In this case, the central point can be the
mixer.
To avoid or solve hum and buzzing troubles, try different combinations of lifting grounds on units that
are supplied with ground lift switches or make sure all chassis are connected to earth ground, either
through the A.C. power cord ground or by the front panel rack mount screws.
To emphasize a frequency range, you don’t necessarily have to move its respective sliding control
upward; try lowering surrounding frequency ranges instead. This way, you avoid causing the next
piece of equipment in your sound path to overdrive. You also preserve valuable dynamic reserve
(“headroom”)
WARRANTY: Till one year after date of purchase.
When connecting the other parts of your sound system, watch out for the so-called “ground loops”.
3
Splash Series Active / Passive
Ordercode: D3588 – D3595
International
EU Cable
UK Cable
US Cable
Pin
L
BROWN
RED
YELLOW/COPPER
FASE
N
BLUE
BLACK
SILVER
NUL
YELLOW/GREEN
GREEN
GREEN
EARTH
Connection with the mains
Connect the device to the mains with the power-plug.
Always pay attention, that the right color cable is connected to the right place.
Make sure that the device is always connected properly to the earth!
Improper installation can cause serious damage to people and property!
Return Procedure
Returned merchandise must be sent prepaid and in the original packing, call tags will not be issued.
Package must be clearly labeled with a Return Authorization Number (RMA number). Products returned
without an RMA number will be refused. Highlite will not accept the returned goods or any responsibility.
Call Highlite 0031-455667723 or mail aftersales@highlite.nl and request an RMA prior to shipping the fixture.
Be prepared to provide the model number, serial number and a brief description of the cause for the
return. Be sure to properly pack fixture, any shipping damage resulting from inadequate packaging is the
customer’s responsibility. Highlite reserves the right to use its own discretion to repair or replace
product(s). As a suggestion, proper UPS packing or double-boxing is always a safe method to use.
Note: If you are given an RMA number, please include the following information on a piece of paper
inside the box:
1) Your name
2) Your address
3) Your phone number
4) A brief description of the symptoms
Claims
The client has the obligation to check the delivered goods immediately upon delivery for any shortcomings and/or visible defects, or perform this check after our announcement that the goods are at their
disposal. Damage incurred in shipping is the responsibility of the shipper; therefore the damage must be
reported to the carrier upon receipt of merchandise.
It is the customer's responsibility to notify and submit claims with the shipper in the event that a fixture is
damaged due to shipping. Transportation damage has to be reported to us within one day after receipt
of the delivery.
Any return shipment has to be made post-paid at all times. Return shipments must be accompanied with
a letter defining the reason for return shipment. Non-prepaid return shipments will be refused, unless
otherwise agreed in writing.
Complaints against us must be made known in writing or by fax within 10 working days after receipt of the
invoice. After this period complaints will not be handled anymore.
Complaints will only then be considered if the client has so far complied with all parts of the agreement,
regardless of the agreement of which the obligation is resulting.
4
Splash Series Active / Passive
Ordercode: D3588 – D3595
Features
The Splash series is a line of lightweight and easy to handle speakers. In this series, DAP Audio managed
to combine good acoustics with state-of-the-art technology for a very affordable price. The robust
housing features 3 grips for easy handling, transportation and a pole mount. The special shaped side and
the excellent gain before feedback makes it also possible to use the Splash series as a stage monitor
speaker. These properties make this series suitable for musicians, small bands, DJ systems, fixed
installations, bars and other areas.
8A/10A/12A/15A
Compact, lightweight and robust ABS housing,
Switchable contour function,
High sound pressure,
Universally applicable.
8/10/12/15
Compact, lightweight and robust ABS housing,
Universally applicable,
High sound pressure.
5
Loading...