DAPAudio PA-7120, ZA-7250, PA-16120 User Manual
PA-7120 V1
Highlite Interna t ional B.V. – Vestastraat 2 – 6468 EX – Kerkrade – the Netherlands
Ordercode: D6151
MANUAL
ENGLISH
PA-7120
Ordercode: D6151
Table of contents
Warning ............................................................................................................................................................................... 2
Safety Instructions ......................................................................................................................................................... 2
Operating Determinations .......................................................................................................................................... 4
Connection with the mains......................................................................................................................................... 4
Return Procedure .......................................................................................................................................................... 4
Claims .............................................................................................................................................................................. 4
Description of the device ................................................................................................................................................. 5
Overview ........................................................................................................................................................................ 5
Frontside.......................................................................................................................................................................... 6
Backside ......................................................................................................................................................................... 8
Installation .........................................................................................................................................................................12
Set Up and Operation .....................................................................................................................................................12
Connecting Inputs ......................................................................................................................................................12
Connecting Outputs ..................................................................................................................................................13
Low Impedance Outputs .......................................................................................................................................13
High Impedance Outputs ......................................................................................................................................13
Connection Cables .........................................................................................................................................................14
Maintenance ....................................................................................................................................................................15
Replacing the Fuse .....................................................................................................................................................15
Troubleshooting ...............................................................................................................................................................15
Product Specifications ....................................................................................................................................................16
1
PA-7120
Ordercode: D6151
Warning
Unpacking Instructions
Immediately upon receiving this product, carefully unpack the carton and check the contents to ensure
that all parts are present, and have been received in good condition. Notify the dealer immediately and
retain packing material for inspection if any parts appear damaged from shipping or the carton itself
shows signs of mishandling. Save the carton and all packing materials. In the event that a device must be
returned to the factory, it is important that the device is returned in the original factory box and packing.
Your shipment includes:
• DAP Audio PA-7120
• Power cable (1,5 m)
• User manual
Safety Instructions
Every person involved with the installation, operation and maintenance of this system has to:
• be qualified
• follow the instructions of this manual
Before you initial start-up, please make sure that there is no damage caused by transportation. Should
there be any, consult your dealer and do not use the system.
To maintain perfect condition and to ensure a safe operation, it is absolutely necessary for the user to
follow the safety instructions and warning notes written in this manual.
Please consider that damages caused by manual modifications to the system are not subject to
warranty.
This system contains no user-serviceable parts. Refer servicing to qualified technicians only.
2
PA-7120
Ordercode: D6151
IMPORTANT:
The manufacturer will not accept liability for any resulting damages caused by the non-observance of
this manual or any unauthorized modification to the system.
• Never let the power cord come into contact with other cables! Handle the power cord and all
connections with the mains with particular caution!
• Never remove warning or informative labels from the unit.
• Never use anything to cover the ground contact.
• Never leave any cables lying around.
• Do not insert objects into air vents.
• Do not connect this system to a dimmerpack.
• Do not switch the system on and off in short intervals, as this would reduce the system’s life.
• Do not open the device and do not modify the device.
• Do not drive the inputs with a signal level bigger, than required to drive the equipment to full output.
• Do not plug mics into the console (or stagebox) while phantom power is on. Also mute the monitor /
Pa system when turning phantom power on or off. Allow the system to adjust for a couple of
seconds, before setting the input gains.
• Only use system indoors, avoid contact with water or other liquids.
• Avoid flames and do not put close to flammable liquids or gases.
• Always disconnect power from the mains, when system is not used. Only handle the power cord by
the plug. Never pull out the plug by tugging the power cord.
• Always operate the unit with the AC ground wire connected to the electrical system ground.
• Make sure you do not use the wrong kind of cables or defective cables.
• Make sure that the signals into the mixer are balanced, otherwise hum could be created.
• Make sure you use DI boxes to balance unbalanced signals; All incoming signals should be clear.
• Make sure that the available voltage is not higher than stated on the rear panel.
• Make sure that the power cord is never crimped or damaged. Check the system and the power
cord from time to time.
• Please turn off the power switch, when changing the power cord or signal cable, or select the input
mode switch.
• Extreme frequency boosts in connection with a high input signal level may lead to overdriving your
equipment. Should this occur, it is necessary to reduce the input signal level by using the INPUT
control.
• To emphasize a frequency range, you do not necessarily have to move its respective control
upward; try lowering surrounding frequency ranges instead. This way, you avoid causing the next
piece of equipment in your sound path to overdrive. You also preserve valuable dynamic reserve
(“headroom”).
• Avoid ground loops! Always be sure to connect the power amps and the mixing console to the
same electrical circuit to ensure the same phase!
• If system is dropped or struck, disconnect mains power supply immediately. Have a qualified
engineer inspect for safety before operating.
• If the system has been exposed to drastic temperature fluctuation (e.g. after transportation), do not
switch it on immediately. The arising condensation water might damage your system. Leave the
system switched off until it has reached room temperature.
• If your Dap Audio device fails to work properly, discontinue use immediately. Pack the unit securely
(preferably in the original packing material), and return it to your Dap Audio dealer for service.
• Repairs, servicing and electric connection must be carried out by a qualified technician.
• For replacement use fuses of same type and rating only.
• WARRANTY: Till one year after date of purchase.
3
PA-7120
Ordercode: D6151
International
EU Cable
UK Cable
US Cable
Pin
L
BROWN
RED
YELLOW/COPPER
PHASE
N
BLUE
BLACK
SILVER
NEUTRAL
YELLOW/GREEN
GREEN
GREEN
PROTECTIVE GROUND
Return Procedure
Operating Determinations
This system is not designed for permanent operation. Consistent operation breaks will ensure that the
system will serve you for a long time without defects.
If this system is operated in any other way, than the one described in this manual, the product may suffer
damages and the warranty becomes void.
Any other operation may lead to dangers like short-circuit, burns, electric shock, etc.
You endanger your own safety and the safety of others!
Improper installation can cause serious damage to people and property !
Connection with the mains
Connect the device to the mains with the power-plug.
Always pay attention, that the right color cable is connected to the right place.
Make sure that the device is always connected properly to the earth!
Improper installation can cause serious damage to people and property!
Returned merchandise must be sent prepaid and in the original packing, call tags will not be issued.
Package must be clearly labeled with a Return Authorization Number (RMA number). Products returned
without an RMA number will be refused. Highlite will not accept the returned goods or any responsibility.
Call Highlite 0031-455667723 or mail aftersales@highlite.nl
Be prepared to provide the model number, serial number and a brief description of the cause for the
return. Be sure to properly pack fixture, any shipping damage resulting from inadequate packaging is the
customer’s responsibility. Highlite reserves the right to use its own discretion to repair or replace
product(s). As a suggestion, proper UPS packing or double-boxing is always a safe method to use.
Note: If you are given an RMA number, please include the following information on a piece of paper
inside the box:
01) Your name
02) Your address
03) Your phone number
04) A brief description of the symptoms
and request an RMA prior to shipping the fixture.
Claims
The client has the obligation to check the delivered goods immediately upon delivery for any shortcomings and/or visible defects, or perform this check after our announcement that the goods are at their
disposal. Damage incurred in shipping is the responsibility of the shipper; therefore the damage must be
reported to the carrier upon receipt of merchandise.
It is the customer's responsibility to notify and submit claims with the shipper in the event that a fixture is
damaged due to shipping. Transportation damage has to be reported to us within one day after receipt
of the delivery.
Any return shipment has to be made post-paid at all times. Return shipments must be accompanied with
a letter defining the reason for return shipment. Non-prepaid return shipments will be refused, unless
otherwise agreed in writing.
Complaints against us must be made known in writing or by fax within 10 working days after receipt of the
invoice. After this period complaints will not be handled anymore.
Complaints will only then be considered if the client has so far complied with all parts of the agreement,
regardless of the agreement of which the obligation is resulting.
4
PA-7120
Ordercode: D6151
• Dimensions:
330 x 482 x 95 mm (LxWxH)
19” x 2HE (LxH)
Fig. 01
Description of the device
Features
The DAP PA-7120 is a 120W, 100V amplifier mixer with 4 selectable sources and 3 microphone inputs. All
microphone inputs are equipped with phantom power and can be selected as line input. The integrated
speech filter can be applied to improve the audibility. It has 3 dedicated line inputs on the backside and
a special easy access line/phone front input to connect mp3 players or mobile devices. The amplifier has
such enhanced features as, priority, chime with adjustable level, emergency input, ducking level control,
loop through connection and the output which can be set as line output, music only or microphone only.
Outputs
• Power consumption: 120W
• Zones: 1
• 100V & 8Ω: Terminals
• Line output: XLR
• Loop through: RCA
• Headphones: 6,3 mm jack
Inputs
• 3 x Mic/Line: XLR/jack combo & terminals
• 3 x Line: RCA
• Front input: 3,5 mm jack
Features
• Speech filter: -3dB, 300Hz 6dB/oct
• Phantom power: 18V
• Tone control: Bass 100 Hz, treble 12 KHz, +/- 12dB
• Chime: adjustable volume
• Ducking: adjustable suppression
• PTT: Mic input 1
• VOX: Mic input 2
• Telephone input: override all, terminal
General
• Power supply: 230V AC, 50 Hz
• Back-up power supply: 24V DC
• Power consumption: 250W
• Power connection: IEC power connector
• Fuse: T4AL/250V
• Weight: 9,2 kg
Overview
5
Loading...