![](/html/1d/1d35/1d350be0c9c1c1e068f89a5115437c92fa857adb44f215f2539e6c066d9e5fca/bg2.png)
2
UK user manual © 2008 danita electronics a/s
danita CB radio
For Your Safety
The danita CB transceiver is a high quality product, designed
for long lasting and dependable service. To get full benefit from
it, please follow the instructions in this manual carefully.
Included
Delivered with:
- DC cable
- Mounting bracket
- Microphone
- Microphone holder
- User manual
Note
danita 2000 Multi is tested in accordance with Directive
1999/5/EC.
In general it is legal to use any of danita models in all of the
countries in EU, as long as the danita 2000 Multi is only used
according to the rules of the individual country. For example
in CH, DK, NO, SE and SK the FM modulation is the only one
to be used. (Select 06 in country selector)
If you are in doubt, check with your dealer.
danita 2000 Multi must not be used in ways that can hurt you
or others. For your safety and protection do not use danita
2000 Multi in any ways other than described in this manual.
![](/html/1d/1d35/1d350be0c9c1c1e068f89a5115437c92fa857adb44f215f2539e6c066d9e5fca/bg3.png)
3
If your transceiver does not work properly, first check tha
all controls are set as instructed in the manual. If this does
not change the situation, do not attempt to fix the transceive
yourself, but take the unit to your dealer. Please enclose a
short description of the fault.
To clean the transceiver just use a damp cloth.
Important
The device is not to be discarded through regular waste
disposal. Instead please dispose of it in a responsible
manner, e.g. at a recycling centre.
Service
How To Use danita 2000 Multi
Ensure the connection of a suitable antenna and make
sure power is on. Set the volume control to about medium
and turn the squelch control until the noise just disappear.
Hold the microphones about 2” from your mouth. Press the
microphones transmit button, and speak clearly. Release
transmit button, and listen to the other part.
Country Selection
When danita 2000Multi is turned on, the display flash with
two digit. 06 may be used in all countries. To change country selection, press UP knob for 3 second, when danita
2000Multi is turned ON. Select with UP/DN knobs. Keep
DN knob pressed for 3 second for store new country.
Choose 06 for the following countries: AT, CH, CZ, DE,
DK, GB, HU, IS, LT, LU, LV, NO, PT, SE, SI, SK and SR.
Choose 05 for these countries: BE, EE, ES, FI, FR, GR,
IE and NL.
See the manual, danita 2000Multi Country Selection, for
more information. Also for DE, GB, IT and PL.
![](/html/1d/1d35/1d350be0c9c1c1e068f89a5115437c92fa857adb44f215f2539e6c066d9e5fca/bg4.png)
1. MICROPHONE CONNECTOR
Insert the microphone plug here.
2. ON/OFF SWITCH AND VOLUME CONTROL
The ON/OFF switch and volume control are combined. Turn the knob
clockwise to turn the radio on and to increase the volume.
3. SQUELCH
The squelch is used to eliminate unwanted noise. The squelch should
be adjusted clockwise to the point where the noise in the loudspeaker
just disappears.
4+5. CHANNEL SELECTOR
The desired channel is selected by the UP/DN knobs.
6. DISPLAY
Show the channel. When turn up, it show the country select digit.
7+8. AM/FM.
If country selection has AM/FM modulation, this button “7” is used
for choosing modulation. FM LED “8” light up at FM.
9+10 DX/LO.
Lower the receiver signal by app. 20dB when “10” light up.
11 TX/RX LED
LED light green at receiving and red at transmitting.
Switch when press the microphones transmit button.
7 9 8 2 10 3 11 4 6 5 1
![](/html/1d/1d35/1d350be0c9c1c1e068f89a5115437c92fa857adb44f215f2539e6c066d9e5fca/bg5.png)
12. ANTENNA
UHF / PL connector. Connect an antenna specially designed for 27 MHz
here. The antenna and cable should be of 50 Ohm’s impedance.
13. EXT.
An external loudspeaker of 8 Ohm’s impedance can be connected to this
3.5 mm jack.
When the plug is connected, the build in speaker is automatically
disconnected.
14. 13.8V DC
12-15 Volt DC should be connected to negative (black cable) and positive
(red cable).
13 14 12
Notification
danita electronics a/s hereby declare that danita 2000Multi complies with
the essential requirements in the Directive 1999/5/EC.
The original EU declaration can be seen at www.danita.eu , English page,
CB radios, Technique.
May be used in:
AT, BE, BG, CH, CZ, DE, DK, EE, FI, FR, GB, HU, IE, IS, IT, LT, LU,
LV, NL, NO, PL, PT, RO, SE, SI og SK.