Data sheet | Non return valve VCM 92
Table of Contents
1. Introduction
1. Introduction ............................................................................2
2. Features ................................................................................2
3. Technical data and code numbers .......................................................2
4. Filtration................................................................................3
5. Dimensions .............................................................................3
6. Flow versus pressure charts .............................................................4
The non-return valve is designed for use in
Seawater Reverse Osmosis (SWRO) membrane
systems. In case the high-pressure pump stops
momentarily, the volume of water in the
membrane vessel may work as an accumulator
and will send ow backwards. In case pumps are
placed in parallel, the non-return valve also
prevents that water from one pump runs into the
parallel-coupled pumps at start-up.
The function of the valve is prepared for easy
installation on the high-pressure outlet.
Typically used in connection with APP 53 - 92
pumps.
3. Technical data
and code numbers
VCM 92
The non return valve is designed for use with low
The sealing is a FKM 75 O-ring.2. Features
viscosity and corrosive uids such as sea water.
All wetted parts are made of highly corrosion
resistant materials such as Super Duplex
(EN1.4410/UNS S32750/SAF 2207) stainless steel
and carbon reinforcec PEEK.
Typ e Max.
pressure
barg (psig)
VCM 92 83 (1200) 92 (405) 0.05 (7.2) 0.4 (7.8)
Flow
continuously
m³/h (gpm)
Opening
pressure
barg (psig)
Pressure
loss at
max. ow
barg (psig)
Inlet
connection
Flange with
8 screws
M12x25
Net weight: 5.2 kg (11.4 lb)
Materials: Superduplex, PEEK, PP, Hasteloy, FKM, NBR
Min. ow continuous: 20 m³/h (88 gpm)
Outlet
connection
Victaulic 3” 180H0058
Code
number
2 | © Danfoss | DCS (im) | 2020.01 AI299347292185en-000501