Data sheet
Thermostat type AT
Application
Technical Data
The AT pipe thermostat is used to regulate the
medium temperature in the pipe on which the
thermostat is mounted. AT senses the temperature
in the pipe through its contact surface and is
therefore suitable to control boiler or flow
temperature in central heating systems.
The AT pipe thermostat comprises a bimetallic
sensor, a contact system and a setting knob.
On connection to terminals CO and NC the
thermostat breaks on a rise in temperature.
On connection to terminals CO and NO the
thermostat closes on a rise in temperature.
The AT thermostat can be mounted on the pipe
without emptying the plant of water.
Temperature range 30 to 90 °C
Temperature scale external (type 041E0000)
Temperature differential 8 K
Max. temperature plant surface Ts90
Max. ambient temperature 55 °C
Storage temperature -20 to 90 °C
Switch system SPDT
Enclosure IP40
Terminal CO-NC Breaks on temperature rise
Terminal CO-NO Closes on temperature rise
Switch load
-marking in accordance with the directives
Environment Normal
Installation Installed in any position
6 (2.5) A, 250 Vac
0.1 A, 250 Vdc
• EMC
• LVD
• RoHS
Accessories
© Danfoss | 2021.05
Product Code no.
Heat-conductive compound ~ 6 g 041E0115
Heat-conductive compound ~ 454 g 041E0116
AI040586453748en-010201 | 1
Data sheet Thermostat type AT
Installation
Electrical connections Internal ground terminal screw in the base, M3.5.
The AT thermostats are mounted directly on a
pipe with the steel band provided, suitable for
pipe sizes G ½ to 3.
A tube containing heat-conductive compound is
supplied with the thermostat. The compound has
very good heat conducting properties and should
be applied between the thermostat contact
surface and the pipe.
Alternatively, plug connection (AMP).
Electrical connection, M3.5 screw terminals or
plug (AMP).
Dimensions
Additional documentation on burner components is available on http://heating.danfoss.com/
2 | © Danfoss | DCS-SGDPT/DK | 2021.05
AI040586453748en-010201