Danfoss NRVS 15, NRVS 25 Installation guide

Installation Guide

Check valve
NRVS 15-25

020R9508

020R9508

1

2

Type Bolt Max tightening torque

Nm LB-feet

NRVS 15 2 x M12 50 37

3

© Danfoss A/S (AC-MCI/MWA), 2013-10 DKRCI.PI.FI0.A2.02 / 520H3379 1

NRVS 25 2x M 12 70 52

Installation

ENGLISH

Assembly

Remove welding debris and any dirt from pipes and
valve body before assembly.

Refrigerants

Applicable to HCFC, HFC and R717 (Ammonia).
Flammable hydrocarbons are not recommended.
The valve is only recommended for use in closed
circuits. For further information please contact
Danfoss.

Installation

The valve must be installed in the flow direction as
indicated by the arrow on the valve housing (fig. 1).
The valve is designed to withstand a high internal
pressure. However, the piping system should be
designed to avoid liquid traps and reduce the risk
of hydraulic pressure caused by thermal expansion.
It must be ensured that the valve is protected from
pressure transients like “liquid hammer” in the
system.

Welding

The internal parts should be removed before
welding (fig. 2) to prevent damage to the gaskets,
as well as the teflon gasket in the valve seat.
Only materials and welding methods, compatible
with the flange material, must be welded to the
flanges. The flanges should be cleaned internally to
remove welding debris on completion of welding
and before the valve is reassembled.

Be careful not to damage the teflon on the cone.

The valve inclusive flanges must be free from
stresses (external loads) after installation.

The valves must not be mounted in systems where
the outlet side of the valve is open to atmosphere.
Both the inlet and outlet side of the valve must
always be connected to the system or properly

capped off, for example with a welded-on end

plate.

Tightening

Thighten the staybolts and nut with a torque
wrench, to the values indicated in the table (fig. 3).

Surface protection

The external surface of the flanges must be
prevented against corrosion with a suitable
protective coating after installation and assembly.

Maintenance

Dismantling the valve

Do not remove the valve housing while the valve is
still under pressure.

- Check that the gasket has not been damaged.

Assembly

Remove any dirt from the body before the valve is
assembled.

Tightening

Tighten the staybolts and nut with a torque wrench,
to the values indicated in the table (fig. 3).

Use only original Danfoss parts, including gaskets
for replacement. Materials of new parts are certified
for the relevant refrigerant.

In cases of doubt, please contact Danfoss.
Danfoss accepts no responsibility for errors and
omissions. Danfoss Industrial Refrigeration reserves
the right to make changes to products and
specifications without prior notice.

2 DKRCI.PI.FI0.A2.02 / 520H3379 © Danfoss A/S (AC-MCI/MWA), 2013-10