Danfoss Frequency Channel Change Procedure Operating guide
User Manual
Ikontrol and Handheld Transmitters
Frequency Channel Change Procedure
www.danfoss.com
User Manual
Ikontrol and Handheld Transmitters Frequency Channel Change Procedure
Revision history Table of revisions
Date Changed Rev
November 2019 Converted to Danfoss layout 0101
2 | © Danfoss | November 2019 AQ314069280700en-000101
User Manual
Ikontrol and Handheld Transmitters Frequency Channel Change Procedure
Contents
Ikontrol family and handheld transmitters
Changing radio frequency overview.........................................................................................................................................4
Ikontrol transmitter frequency channel change procedure
Make current RF channel programmable................................................................................................................................5
Programming / Modifying the current RF channel..............................................................................................................6
Handheld transmitter frequency channel change procedure
Make current RF channel programmable................................................................................................................................8
Programming / Modifying the current RF channel..............................................................................................................9
Channel / Frequency correspondence
Rest of the world............................................................................................................................................................................ 11
Europe................................................................................................................................................................................................12
USA......................................................................................................................................................................................................13
USA and CANADA..........................................................................................................................................................................14
©
Danfoss | November 2019 AQ314069280700en-000101 | 3
W
User Manual
Ikontrol and Handheld Transmitters Frequency Channel Change Procedure
Ikontrol family and handheld transmitters
Changing radio frequency overview
The radio frequency via the transmitter can be changed in a simple way. The receiver will automatically
search for this new frequency.
Both Ikontrol and handheld transmitters radio systems contain dual band radio modules which are
microprocessor controlled.
Transmission channel (CB) is defined as the working channel. It is factory defined unless specified at the
time of ordering the system. It can also be modified via the frequency channel change mode.
The change of frequency is made via commands that in normal work mode will operate or move the
machine.
The programming sequence must be strictly followed to avoid any movement of the machine.
Warning
Unintended movement of the machine or mechanism may cause injury to the technician or bystanders.
To protect against unintended movement, secure the machine.
4 | © Danfoss | November 2019 AQ314069280700en-000101
User Manual
Ikontrol and Handheld Transmitters Frequency Channel Change Procedure
Ikontrol transmitter frequency channel change procedure
Make current RF channel programmable
1. Release the STOP button.
2. Move toggle switch to maneuver point to the Triangle + Start.
In approximately 5 seconds the LED will blink in Red until LED turns to Amber.
The LED will signal the current RF channel:
Number of Green blinks = RF channel Tens
•
Number of Red blinks = RF channel Units
•
©
Danfoss | November 2019 AQ314069280700en-000101 | 5
Loading...