Danfoss Floor Sensor Data sheet

Data Sheet Floor Sensor

General
Information

Instructions

Ordering
Information

The replacement oor sensor is used with
the programmable and non-programmable
thermostat.

It comes with 9 feet of lead wire.

1. The oor sensor should be 10” (25 cm) away from the wall.

2. The oor sensor should be installed in the conduit tube.

3. The oor sensor must be centered in the cable loop (between two RED heating wires).

4. Use the duct tape to hold the oor sensor into the groove to prevent it from oating up when
the thin set is poured.

Part No. Description

088L3008 Replacement Floor Sensor for LX Thermostat

Accessories

Application

Warranty

Technical
Services

Danfoss can accept no responsibility for possible errors in catalogs, brochures, other printed materials, and website information. Danfoss reserves the right to alter its
products without notice. This also applies to products already on order provided that such alteration can be made without subsequent changes being necessary in

specications already agreed upon. All trademarks in this material are property of the respective companies. Danfoss and Danfoss logotype are trademarks of Danfoss A/S. All rights reserved.

Part No. Description

19809099 Sensor Conduit (8 feet)

Product in this data sheet is for use with these Danfoss heating mats and cables.

LX Electric Floor Heating Mats
LX Electric Floor Heating Cables
TX-FH Floor Heating Cables
TX-SH Storage Heating Cables

Genuine two year warranty against defects in material, design, and workmanship.

For technical questions, please contact Danfoss Heating Division North America at 1-866-676-8062.
More information on Danfoss Electric Heating products is available at www.LX.Danfoss.com.

Danfoss
Toronto

Toll Free: 1-866-676-8062
Tel.: [phone]
Fax: [phone]
www.LX.Danfoss.com

Danfoss LX

BRINGING WARMTH TO LIFE

© Copyright 2014 Danfoss NA.EFH.LXD.09/14 TEL: [phone], FAX: [phone] 1