
安装说明
FH-PROX-B
型分集水器
阀杆水平位置
阀杆垂直位置
排气开启
分集水
器开启
泄水关闭
排气开启
分集水
器开启
泄水开启
© Danfoss | FEC | 2021.11
AN396782666462zhCN0101 / 088U7109 | 1

安装说明 FH-PROX-B 型分集水器
FH-PROX-B 安装注意事项
技术参数
安装关断阀芯步骤
1. 与主管连接的末端装置及管道连接件应采用端面带有 橡胶密封的1寸管螺纹,旋进分集水器主管
的螺纹长度应不大于14mm;
2. 打压时,分集水器供回水管的阀门必须处于全开位置;
3. 为防止终端用户的误操作开启末端排气组件的泄水功能,需要使用配套的端盖进行开关操作。
试验压力 16 bar
最高工作压力 10 bar
最高供水温度 90 °C
注意:最高工作压力和温度不能超过管材供应商所要求的参数。
10 mm
特殊工具
特殊工具
10 Nm
分集水器的关断功能
特殊工具
5 mm
088U0926
Open
2 | © Danfoss | FEC | 2021.11
AN396782666462zhCN0101 / 088U7109

Installation Guide
FH-PROX-B
Manifold
© Danfoss | FEC | 2021.11
Airvent open
Stem Horizontal
Manifold
open
Purge close
Airvent open
Stem Vertical
Manifold
open
Purge open
AN396782666462zhCN0101 / 088U7109 | 3

FH-PROX-B
Installation guide
1. The end piece and pipe connectors connected to manifold should be G1” thread and
sealed by rubber sealing material at the end, the length of thread inserted into the manifold should be less than 14 mm.
2. The valves in both flow and return manifold should be fully opened during pressure testing.
3. In order to prevent the misoperation of the end user to open the drain function of airvent
end piece, it is necessary to use the matching end cap for switching operation.
-
Technical Data
Install shut o insert
steps
Test pressure 16 bar
Max. working pressure 10 bar
Max. flow temperature 90 °C
Note: Maximum operating pressure and temperature given by the pipe manufacturer must not be exceeded.
10 mm
Special tool
Special tool
10 Nm
4 | © Danfoss | FEC | 2021.11
Manifold with shut o function
Special tool
5 mm
088U0926
Open Shut o
AN396782666462zhCN0101 / 088U7109