Danfoss Devilink PR Operating guide

Devilink™ PR – Plug in Relay Installation Manual
INT
d ev ir eg 5 50
d evir eg5 50
22.
0
22.
0
2
1. Applications and Functions Devilink™ PR
The Devilink™ PR (Plug in relay) is a device for switching heating elements or other electrical equipments ON/OFF, either manually or by schedule.
Installation scenario:
Devilink™ RS
Devilink™ PR
Devilink™ CC
LED indikator
Push and hold for approx. 5 sec. to install or connect
3
Placement of Devilink™ PR
Installation and placement must be according to local building regulations.
Operation modes
Devilink™ PR supports two types of operation modes.
1. Heating regulation
2. ON/OFF switching
When using Devilink PR as heating regulation you also have to install a Devilink RS and consider the following advices for controlling the heating.
Do not install floor heating system without a floor sensor
when the heating element is installed on or beneath
wooden surfaces and other surfaces
sensitive to temperature!
4
3. Light indications (LED)Installation of Devilink™ PR
Installation of Devilink™ PR
1. Devilink™ PR is to be put in to a Schucko socket/outlet.
Configuration:
See Step-by-Step guide in Devilink™ CC instruction manual.
NB! Heating elements which is connected to
Devilink™ PR have to be self protective
against overheating.
5
Green LED ON Relay ON
Red LED ON Relay OFF
Green LED fast flash Inclusion or link test
Red LED short flash Inclusion not OK, goes to not
Factory reset of Devilink™ PR
Disconnect the unit to cut off power. Hold the install button in while reconnecting power. Keep pressing the install button until the LED gives a red flash. (approx. 5 sec).
included. Linktest not OK, goes to missing link
6
Disposal Instruction
7
Technical specifications
Operation voltage 230 V AC, 50 Hz
Standby consumption <1W
Load
Regulation PWM
Ambient temperature 0˚ to +35˚C
Transmission frequency
Transmission range in normal buildings
Transmission power Max. 1 mW
IP class 20
Dimensions 106 mm × 59 mm × 75 mm
2300 W, 460 VA, 600 W Incandescent Bulbs
868.42 MHz
Up to 30 m
8
The 2 Year DEVI Warranty
You have purchased a DEVI heating system which we are sure will serve to improve the comfort and economy of your application.
DEVI provides superior electrical heating solutions for total climate control in and around homes and buildings. DEVI offers a complete product program with DeviflexTM heating cables or DevimatTM heating mats, DeviregTM thermostats, DevifastTM fixing strips and Devi Self-limiting heating cables combined with additional products completing the product program.
This 2 year warranty applies to all DEVI products.
Should you, against all expectations, experience a problem with your DEVI product, you will find that DEVI offers a 2 year warranty from the date of purchase on the following conditions:
During the warranty period DEVI shall offer a new comparable product or repair the product in case the product is found to be faulty by reason of defective design, materials or workmanship. Repair or replacement shall be carried out at DEVI’s discretion. DEVI shall not be liable for any consequential or incidental damages including, but not limited to, damages to property or extra utility expenses.
This warranty shall only be valid on production of proof of purchase and must be submitted to the installer or seller without undue delay.
An extension of the warranty period following repairs undertaken under warranty cannot be granted.
The DEVI Warranty shall not cover any damage caused by incorrect conditions of use, incorrect installation or if installation has been carried out by non-authorised electricians. All work will be invoiced in full if DEVI is required to inspect or repair faults that have arisen as a result of any of the above.
The DEVI Warranty shall not extend to equipment which has not been paid in full.
DEVI will, at all times, provide a rapid and effective response to all complaints and inquiries from our customers.
The warranty explicitly excludes all claims exceeding the above conditions.
9
The 2 Year DEVI Warranty
Warranty Certificate
The DEVI™ Warranty is granted to:
Name:
Address
City:
The Warranty Certificate must be completed correctly for the Warranty to be valid.
Type of thermostat:
Article number:
Suppliers Stamp:
Please read the Warranty conditions above.
Attention:
Electrical installation by:
Date:
Telephone:Country:
10
11
Article No: 08095964 Version: 01.02
DEVI A/S
DK • 7100 Vejle
Phone +45 7488 8500 Fax +45 7488 8501
VIFRR102 © Danfoss 09/2009
Loading...