Danfoss DEVIhightemp Data sheet

Data Sheet

DEVIhightemp™ (DSIX)

Double insulated high-temperature silicone heating cable on drum.

Suitable for technological high-temperature heating. It has increased flexibility and can be used to protect the cold room doors from the freezing.

DEVIhightemp™ (DSIX) is manufactured as a single conductor heating cable without screen.

Contact with oil-containing medium is prohibited. The cable is not approved for use in drinking water.

DEVIhightemp™ can be customized for the specific project, depending on voltage, required output, length of heating cable and length of cold leads.

Note: It is the full responsibility of the installer/designer to use proper cold lead dimensioned ! for the purpose and assembly sets that establish sufficient mechanical strength,

flammability resistance and water tightness - and to design the heating unit with correct output for the specific application to avoid overheating of the cable or building materials.

Benefits:	Type	Value
• Easy to install	Nominal voltage, max.		400 V~
• Cut to length on site	Construction		Round, single conductor
• High temperature cable	Outer sheath		Double layer silicone insulation
Standard compliance:	Output, max.		40 W/m
• SS 4242411	Max. permissible use temperature, powered		170 °C
Approvals:	Minimum use temperature		- 51 °C
	Cable dimensions		Ø 3,8 mm
	Resistance tolerance		+7% ... -4%
	Bending Ø, min.		6 x cable diameter
Types
Item no.	Type	Resistance	EAN no.

03044120	DEVIhightemp™, cut-to-length	550 Ohm/m	5703466027189
03044336	DEVIhightemp™, cut-to-length	74 Ohm/m	5703464007169
03044542	DEVIhightemp™, cut-to-length	8,93 Ohm/m	5703464007176
03044609	DEVIhightemp™, cut-to-length	5,00 Ohm/m	5703464007190
03044633	DEVIhightemp™, cut-to-length	3,34 Ohm/m	5703464007206
03044666	DEVIhightemp™, cut-to-length	2,38 Ohm/m	5703466025123
03044757	DEVIhightemp™, cut-to-length	1,13 Ohm/m	5703464007237

Accessories

Item no.	Type	EAN no.
86000080	Joining-kit for silicone cable with silicon cold leads	5703464006728
19805076	Tape aluminium 38 mm x 50 m, for cables, max. temp. 75 °C	5703435003053

Produced by Danfoss ©

AI319534769519en-000101

1

Data Sheet

Calculated* DEVIhightemp™ lengths for some specific outputs (W/m) and voltages

	Resistance,	Specific output,	12 V			24 V			230 V			400 V
			Length,			Length,			Length,			Length,
	r, Ohm/m	p, W/m			P, W			P, W			P, W			P, W
			m			m			m			m
		40**	0,08		3,2	0,16		6,5	1,6		62	2,7		108
	550	30	0,09		2,8	0,19		5,6	1,8		54	3,1		93
		20	0,11		2,3	0,23		4,6	2,2		44	3,8		76
		10	0,16		1,6	0,32		3,2	3,1		31	5,4		54
		40**	0,22		9	0,44		18	4,2		169	7,4		294
	74	30	0,25		8	0,51		15	4,9		146	8,5		255
		20	0,31		6	0,62		12	6,0		120	10,4		208
		10	0,44		4	0,88		9	8,5		85	14,7		147
		40**	0,63		25	1,27		51	12,2		487	21,2		847
	8,93	30	0,73		22	1,47		44	14,1		422	24,4		733
		20	0,90		18	1,80		36	17,2		344	29,9		599
		10	1,27		13	2,54		25	24,3		243	42,3		423
		40**	0,85		34	1,70		68	16,3		651	28,3		1131
	5,00	30	0,98		29	1,96		59	18,8		563	32,7		980
		20	1,20		24	2,40		48	23,0		460	40,0		800
		10	1,70		17	3,39		34	32,5		325	56,6		566
		40**	1,0		42	2,1		83	19,9		796	34,6		1384
	3,34	30	1,2		36	2,4		72	23,0		689	40,0		1199
		20	1,5		29	2,9		59	28,1		563	48,9		979
		10	2,1		21	4,2		42	39,8		398	69,2		692
		40**	1,2		49	2,5		98	23,6		943	41,0		1640
	2,38	30	1,4		43	2,8		85	27,2		817	47,3		1420
		20	1,7		35	3,5		70	33,3		667	58,0		1160
		10	2,5		25	4,9		49	47,1		471	82,0		820
		40**	1,8		71	3,6		143	34,2		1368	59,5		2380
	1,13	30	2,1		62	4,1		124	39,5		1185	68,7		2061
		20	2,5		50	5,0		101	48,4		968	84,1		1683
		10	3,6		36	7,1		71	68,4		684	119,0		1190

** It’s not recommended to use the heating cable with a maximum output - 40 W/m.

* Cable length calculation formulas

L = U / √(p · r), r = U² / (L² · p), p = U² / (L² · r),

Joining-kit for silicone cable (86000080)

1		2		3		4		5		6		7

where

Metal braided shield

if any

The straight-through joints are staggered

L

– length of heating cable (m);

U

– supply voltage (V);

p

– specific output (W/m);

r

– specific resistance (Ohm/m).

No.

Type

Qty.

1

Shrink hose MRWS 10/3, black

120 mm

2

Straight-through joint Ø 2,6 x Ø 4,2 x 15 mm CUFO

2 pcs.

3

Cable 1,5 q, yellow/green

1000 mm

4

Ending fitting 1,0 q, 6,0 mm Cu

2 pcs.

5

Straight-through joint Ø 1,9 x Ø 3,6 x 15 mm CUFO

2 psc.

6

Silicone hose Ø 3,0 mm

60 mm

7

Cord 1,0 q Cu, silicone insulated, red

1000 mm

8

Plastic bag 170 x 230 x 0,05 mm

1 pc.

2

AI319534769519en-000101

Produced by Danfoss ©