Danfoss Cable Fixture Installation guide

Cable Fixture

8229-2

Part of 103N1007

103N0425

Part of 103N1006

103N0420

Part of 103N1010 (Standard)

103N0489

8228-2

Yoke 103N0126

8229-3

103N1010 (Standard)

Correct Tightening Torque

The cable xture 103N0489 developed by Danfoss provides perfect cord relief.
The number of wires and their outside diameters are irrelevant in that matter. Con­sequently, the existing cable xtures 103N0420 and 103N0425 can be replaced
by this type. The yoke 103N0126, which is part of the cable xtures 103N1006,
103N1007 and 103N1010, remains unchanged.

Note:

When tightening the screws of the yoke, be sure to apply a tightening torque of
min. 0.5 Nm and max. 0.8 Nm. Depending on the type and number of the inserted
cables, tightening torques of 0.9 Nm and higher may lead to deformation or even
destruction of the square-end or the slot of the screw.

Technical Info

Please get in touch with your Danfoss contact if any further information is needed.

Please also visit our Web site:

compressors.danfoss.com

and have a look at our complete product range, news, and literature covering all
your present and future applications.

Danfoss Compressors GmbH • Mads-Clausen-Str. 7 • D-24939 Flensburg / Germany • Tel: [phone] • Fax: [phone] • compressors.danfoss.com

Danfoss can accept no responsibility for possible errors in catalogues, brochures and other printed material. Danfoss reserves the right to alter its products without notice. This also applies to products already
on order provided that such alterations can be made without subsequential changes being necessary in specications already agreed.
All trademarks in this material are property of the respective companies. Danfoss and the Danfoss logotype are trademarks of Danfoss A/S. All rights reserved

REFRIGERATION AND

REFRIGERATION AND
AIR CONDITIONING

AIR CONDITIONING

DEHC.EI.200.K1.02/520N0594 Produced by Danfoss Compressors, DEHC6093, 03.2008