Danelectro D-5 Instructions

FAB

Chorus

EEC Agent:
John Hornby Skewes & Co.,Ltd.
Salem House, Parkinson Approach,
Garforth, Leeds LS25 2HR UK

© EC 2005 Printed in China

D-5

INSTRUCTIONS

FAB

Chorus

D-5 Instructions

TO BEGIN:

• Install 9-Volt battery (included). If using Danelectro’s
“Zero Hum” adapter (Recommended) instead of a battery,
connect this to the “9V DC” jack on the back of the D-5.

• Connect an instrument cable from your guitar to the
“Input” jack. Connect a second cable from the “Output”
jack of the D-5 to the input jack of your amplifier.

CONTROL FUNCTIONS:
DEPTH: Adjusts the depth or range of the chorus. Higher

settings will be more extreme, and may require
adjustment of the Speed control to compensate. Lower
settings will be more subtle.

SPEED: Adjusts the speed of the chorus. This control

interacts with the Depth control—slower Speed
settings will allow higher Depth settings. Then again,
you may like the sound of both controls maxed out!

MIX: This control allows you to mix in some dry signal with

the chorused signal. At the lowest setting, there will
be virtually no chorus effect, at maximum, there will
be chorused sound only. Note that the pedal is loudest
when the Mix control is set to maximum.

DEPTH:

Adjusts the depth or

range of chorus

INPUT 9VDC OUTPUT

BATTERY:Uses one S-006P 9-Volt Battery. Danelectro “VintagePower
Source” batteries are recommended.

BATTERY ELIMINATOR: Uses 9-Volt Battery Eliminator.
Polarity: Center Negative (-). 300mA maximum. Danelectro “Zero Hum”
Battery Eliminators are recommended.

SPEED:

Adjusts the speed

of chorus

MIX:

Adjusts the

mix level