Danelectro D-4 Instructions

FAB

Slap Echo

EEC Agent:
John Hornby Skewes & Co.,Ltd.
Salem House, Parkinson Approach,
Garforth, Leeds LS25 2HR UK

© EC 2005 Printed in China

D-4

INSTRUCTIONS

FAB

Slap Echo

D-4 Instructions

TO BEGIN:

• Install 9-Volt battery (included). If using
Danelectro’s “Zero Hum” adapter (Recommended)
instead of a battery, connect this to the “9V DC”
jack on the back of the D-4.

• Connect an instrument cable from your guitar to
the “Input” jack. Connect a second cable from
the “Output” jack of the D-4 to the input jack of
your amplifier.

• LED light will be on when foot switch is
activated.

CONTROL FUNCTIONS:
REPEAT: This control allows you to set the number

of echoes…from one echo (a single “slap”) at
the minimum setting to a great number of echoes
at the maximum setting.

MIX: This control allows you to mix in some dry

signal with the delayed signal. At minimum set­ting, there will be almost no echo effect. At
maximum, there will be only the echo sound.

REPEAT:

Adjusts the number

of echoes

INPUT 9VDC OUTPUT

BATTERY: Uses one S-006P 9-Volt Battery. Danelectro “Vintage Power
Source” batteries are recommended.

BATTERY ELIMINATOR: Uses 9-Volt Battery Eliminator.
Polarity: Center Negative (-). 300mA maximum. Danelectro “Zero Hum”
Battery Eliminators are recommended.

MIX:

Adjusts the amount

of echo effect