Danelectro D-3 Instructions

FAB

Metal

EEC Agent:
John Hornby Skewes & Co.,Ltd.
Salem House, Parkinson Approach,
Garforth, Leeds LS25 2HR UK

© EC 2005 Printed in China

D-3

INSTRUCTIONS

FAB

Metal

D-3 Instructions

TO BEGIN:

• Connect instrument cable to the IN jack.
Connect amplifier cable to the OUT Jack. If using
an AC Adapter, connect to DC-9V jack. Or use
9Volt battery (included).

• LED light will be on when foot switch is
activated.

CONTROL FUNCTIONS:
LEVEL: This control sets the level of the output to

the amplifier.

TONE: Rotate this control to adjust the EQ.

GAIN: Use this control to set the amount of

Distortion.

caution:
This is a high gain device. Start with the LEVEL

control at 25% and then advance as needed.

GAIN:

Adjusts the amount

of distortion

INPUT 9VDC OUTPUT

BATTERY:Uses one S-006P 9-Volt Battery. Danelectro “VintagePower
Source” batteries are recommended.

BATTERY ELIMINATOR: Uses 9-Volt Battery Eliminator.
Polarity: Center Negative (-). 300mA maximum. Danelectro “Zero Hum”
Battery Eliminators are recommended.

TONE:

Adjusts the EQ

LEVEL:

Adjusts the

output level