D and T FS L4201C User Manual
Printed in Korea
Part No. 942667020001 - 01
TFT-LCD Color Monitor
FS-L4201C
User Manual
English
www.tandberg.net
Parts 3
Connection to Signal Source 4
Out Drawing of product
6
Name and Function 7
Power Management Feature
8
Adjusting OSD 10
Standard Signal Table
12
Pin assignment table of signal connector
13
Specification 15
Troubleshooting
16
Warning
18
INFORMA TION T O USER :
This equipment has been tested and found to comply with the limits of a
Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful
interference in a residential installation.This equipment generates, uses and
can radiate radio frequency energy and,if not installed and used in accorÂdance with the instructions, may cause harmful interference to radio commuÂnications.
However, there is no guarantee that interference will not occur in a particular
installation; if this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to crrent the interference by one or more
of the fllowing measures:
1. Reorient/Relocate the receiving antenna.
2. Increase the separation between the equipment and receiver.
3. Connect the equipment into an outlet on a circuit difference
from that to which the recerver is connected.
4. Consult the dealer or an experienced radio/TV technician for help.
CAUTION
Changes or modifications not expressly approved by the
manufacturer responsible for compliance could void the user's
authority to operate the equipment
Table of Contents
Basic Connection
AC Inlet.
AC on/ off Switch
RCA Coaxial S/PDIF Audio input
9 Pin D-Sub connector for Speaker Out
24 Pin DVI Connector for Digital TMDS
15 Pin D-Sub connector for Analog RGB
User's Manual
42 " LCD Monitor
Parts
Connection to Signal Source
LCD MONITOR User s Manual
3
LCD MONITOR User s Manual
4
This monitor do not provide any other accessaries and
peripheral devices (ex,speaker and signal cable) because
the Tandberg's reguest.
1. Use 220 V or 110 V. (Free Voltage)
2. Connect monitor and Signal Source via Signal cable
3. Power on the monitor and computer.
4. Connection is finished.
D-Sub Analog(Data in)
DVI Digital
< Power source connection >
< Signal cable connection>
Coaxial S/PDIF Input
Audio amp Output
O ut Drawing of product
LCD MONITOR User s Manual
5
LCD MONITOR User s Manual
6
AC Inlet
AC on/off swith
Loading...