Dancing Wings Hobby Night Devil Instruction Manual
Suggested Equipment
Motor: 2216 900-1100KV
ESC: 20A
Propeller: 9-10 inch
Servos: 9g*4
Battery: 3s 2200-2600mAh
Radio≥4CH
Speci�ication
Wingspan: 1000mm
Length: 820mm
Flying Weight≈730g
Accessories include
Power System（Optional）
Preparation Tool
A：wood sheets B1：steel wire pushrod
B2：cabon sheets C1：front landing gear
C2：middle landing gear D1-7：EPP sheets
E：screws,EZ-Connector,servo horn
F1：wireless remote switch (optional)
F2：JST extension wire G：wood sticks
H：propeller I：rubber band
How to Assemble
1.Paste the wood sheet A3 and A1 onto the D1 by foam
glue,pay attention to aim at the preserved holes and put
in the right direction.(paste the other side of D1 in same
way)
2.Take down the wood sheet A2,A4 and A5,and assemble as picture shown.(Do not glue them now)
3.Paste together the finished D1 and components from
step 2,pay attention to the direction of wood sheets A4
and A2.Adjust and paste by glue 502.
Night Devil
Instruction Manual
EPP Airplane
B1
A
A
B2
C1
C2
I
D1
D2
D3
D4
D5
D6
D7
E
F1
F2
G
H
A3
D1
A1
A5X2
A4
A2X2
fuselage head direction
pay attention to the gap direction
alignment hole
4.Assemble the motor and front landing gear onto the
A2 (as picture shown below),fix the motor with screws,fix the landing gear with screws and nuts,connect the
landing gear arm with steel wire pushrod,which insert
through the preserved hole on A4,and finally connect
with the servo.
6.Paste the D5 at the bottom of the fuselage by foam
glue,and pull the JST connector out of the wood sheets.
7.Assemble the landing gear as per the bottom preserved
hole,and fix with screws.
8.Assemble the tail reinforcement,and paste with glue
502.
9.Paste the tail reinforcement at the tail of the fuselage
by foam glue,and pull the JST connector out of the hole.
5.Paste the A6 onto the A5 by glue 502,and assemble the
nuts in the preserved holes on the back side of the A5.
Night Devil
Instruction Manual
EPP Airplane
upward
pay attention to the
gap direction
nut
A9
A9-1
A10
A11
steel wire push rod
nuts
insert
D5
A6
Wheel stopper
A7
A2
A4
A4
Loading...