Dancing Wings LIGHTING EPP Instruction Manual

DW LIGHTING INSTRUCTION MANUAL

Accessories include

A. Wing
B1.B2. Wing Reinforcement carbon sheet
C. Fuselage
D. Tail
E. Push rod*2
F. Motor holder
G. Fuselage
H. Servo horn.Clip*2
I.Prop saver
J. Propeller
K. ESC
L. Motor
M. Foam glue
N. Servo*2

STANDARD SETUP

Preparation Tool

Speci�ication

A

A

B1

C

G

D

F

E

M

J

H I

K

L

N

B2

EPP

Wingspan: 1060mm
Length: 550mm

Flying Weight≈260-280g

Battery: 2s 800mAh
Motor: 1908 2050kv

Propeller: 7*3.5
ESC: 10A
Servos: 9g*2

Radio≥3CH

Suggested Equipment

DW LIGHTING INSTRUCTION MANUAL

How to Assemble

0.01 Apply the foam glue on the edge of the G,and
paste together the C & G into the fuselage as per
the picture shown below.

0.02 Cut apart the cabin at the bottom of the
fuselage by knife.

0.03 Paste the motor (L) onto the motor holder
(F),which pastes at the head of the plane,insert the
motor wire through the fuselage inside.

0.04 Put the ESC (K) inside the cabin,connect it with
motor.

0.07 Insert and glue the servo into the reserve slot
on the wing,and cleanly bury the servo wire into
the slot.

0.05 Apply the foam glue on the edge of the wing
A,and paste together the two wings.

0.06 Insert and glue the carbon rod into the wing.

B1

B2

DW LIGHTING INSTRUCTION MANUAL

0.08 Compare the length of the servo pushrod
wire,confirm the servo horn position, and insert the
horn into the wing.

0.09 Assemble the clip onto the steel wire pushrod
as the picture shown below,assemble the servo arm
on the servo,and connect the horn with servo arm
together by a steel wire pushrod.

0.10 Glue together the wing and fuselage togeth­er,and put the servo wire inside the cabin.

0.11 Paste and glue the vertical tail,keep on the
same line with fuselage.

0.12 Assemble the prop saver and propeller.

DW LIGHTING INSTRUCTION MANUAL

Assemble the battery and receiver,adjust the
C.G.,then you could test flying.

50mm

CG