Dana Innovations D8 User Manual

LINE LEVEL INPUT
RIGHT
LEFT / LFE
PHASE
90 DEG
SPEAKER LEVEL INPUT
STATUS
WIRELESS STATUS
WIRELESS SYNC
WIRELESS
INPUT SELECT
LINE LEVEL
SPEAKER LEVEL
CROSSOVER
50HZ
250HZ
150HZ
75HZ
200HZ
BYPASS
VOLUME
MIN
MAX
REF
WIRELESS INPUT
100 watts
T5AL / 250VAC
CAUTION
REPLACE FUSE ONLY WITH
SAME TYPE AND RATING
ATTENTION
REMPLACER UNIQUEMENT AVEC LE
MEME TYPE ET CALIBRE DU FUSIBLE
ISOLATED
GROUNDED
PHASE
0 DEG
180 DEG
GROUND LIFT
POWER
90 DEG
OFF
ON
STATUS
WIRELESS STATUS
WIRELESS
INPUT SELECT
LINE LEVEL
SPEAKER LEVEL
CROSSOVER
50HZ
250HZ
150HZ
75HZ
200HZ
BYPASS
VOLUME
MIN
MAX
REF
100 watts
T5AL / 250VAC
CAUTION
REPLACE FUSE ONLY WITH
SAME TYPE AND RATING
ATTENTION
MEME TYPE ET CALIBRE DU FUSIBLE
ISOLATED
PHASE
0 DEG
180 DEG
GROUND LIFT
POWER
90 DEG
OFF
ON
WIRELESS
LINE LEVEL
SPEAKER LEVEL
CROSSOVER
50HZ
250HZ
150HZ
75HZ
200HZ
BYPASS
VOLUME
MIN
MAX
REF
SONANCE CABINET SUBWOOFER
D8 QUICKSTART GUIDE
Box Contents
(1) Quickstart Guide
(1) Sonance cabinet speaker (D8)
(1) Right angle IEC power cord (115V versions only)
(2) Right angle RCA adapter
Audio Connections
Your Sonance Cabinet Subwoofer has exible connections that let you use it in a wide variety of audio system congurations.
Line Level
You can connect the subwoofer’s line level Input to a surround processor or receiver’s line-level dedicated subwoofer output or a stereo preamp/integrated amplier’s left and right main outputs. If your receiver has a subwoofer output jack, you can connect your subwoofer, using the LEFT/LFE input (see Figure 1).
Speaker Level Input
The subwoofer’s speaker inputs can be connected to the speaker outputs of a receiver or integrated amp that does not have left and right line-level outputs or a dedicated subwoofer output (see Figure 1).
Ground Lift
Your Sonance Cabinet Subwoofer features a ground lift switch available to eliminate most grounding issues. To reduce the ground current and induced noises, switch the GROUND LIFT from ISOLATED to GROUNDED. Safety is not aected (see Figure 2).
Figure 2: Ground Lift Switch
Power Connection
Your Sonance Cabinet Subwoofer features a removable IEC power connector (see Figure 3). (A power cord is included only with 115V versions of the subwoofer.) Plug the female end of the power cord into the power cord connector on the subwoofer’s rear panel and plug the male end into a grounded wall socket. Do NOT plug the subwoofer’s power cord into a convenience outlet on any other audio or video component.
NOTE: WHEN USING THE SUBWOOFER’S SPEAKER INPUTS WE RECOMMEND THE FOLLOWING MINIMUM SPEAKER WIRE SIZES:
• 16 GUAGE FOR A TOTAL WIRE LENGTH OF UP TO 500’
• 14 GUAGE FOR A TOTAL WIRE LENGTH OF UP TO 1,000’ TO DETERMINE THE TOTAL WIRE LENGTH, ADD THE LENGTHS OF WIRE BETWEEN THE AMPLIFIER AND SUBWOOFER AND BETWEEN THE SUBWOOFER AND THE MAIN SPEAKERS.
Wireless Input
Your Impact Subwoofer comes with a built-in wireless receiver which you can use to receive a signal from your stereo preamp/integrated amplier if you purchase the Transmitter (sold separately). Once you have the Transmitter powered up and plugged in press the wireless sync button (see Figure 1).
Input Select
The Subwoofer’s Speaker Inputs can be selected using the INPUT SELECT toggle (see Figure 1).
IMPORTANT: NO SIGNAL WILL BE PASSED IF THE INPUT SELECT BUTTON IS NOT PROPERLY SELECTED.
IMPORTANT: DO NOT PLUG THE POWER CORD INTO THE WALL OUTLET UNTIL ALL SYSTEM CONNECTIONS HAVE BEEN MADE AND VERIFIED.
NOTE: IF YOU NEED TO USE AN EXTENSION CORD, USE ONLY A HEAVY-DUTY (14-GAUGE OR LARGER) EXTENSION CORD TO AVOID STARVING THE SUBWOOFER OF ALL THE CURRENT NECESSARY FOR FULL-POWER OPERATION.
Figure 3: IEC Power Connector
©2017 Sonance. All rights reserved. Sonance is a registered trademark of Dana Innovations. Due to continuous product improvement, all features and specications are subject to change without notice. For the latest Sonance product specication information visit our website: www.sonance.com
SONANCE • 991 Calle Amanecer • San Clemente, CA 92673 USA(949) 492-7777 • FAX: (949) 361-5151 • Technical Support: (949) 492-7777
Figure 2: Speaker Inputs
33-7915
09.27.17
IMPORTANT SAFETY INFORMATION
nience receptacles, and the point where
to rain.
12. Power Cord Protection Power cords should be routed so that they are not likely to be walked on or pinched by items placed upon or against them, paying particular attention to cords at plugs, conve
nience receptacles, and the point where
they exit from the controller.
13. Cleaning The unit should be cleaned only as recommended by the manufacturer.
14. Non-Use Periods The power cord of the unit should be unplugged from the outlet when left unused for a long peri- od of time.
15. Object and Liquid Entry Care should be taken so that objects do not fall and liquids are not spilled into the enclo- sure through openings.
16. Damage Requiring Service The unit should be serviced by qualified service personnel when:
The power cord or the plug has been damaged.
Objects have fallen or liquid has been spilled into the unit.
The unit has been exposed
to rain.
The unit does not appear to operate normally or exhibits a marked change in performance.
The unit has been dropped or the enclosure damaged.
17. Servicing The user should not attempt to service the unit beyond that described in the operating instructions. All other servicing should be referred to qualified service per- sonnel.
The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to aler t the user to the presence of uninsulated dangerous voltage within the products enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons.
The exclamation point within an equilateral triangle is intended to alert the user to the presence of important operat- ing and maintenance (servicing) instructions in the literature accompanying the appliance.
TO PREVENT FIRE OR SHOCK HAZARD, DO NOT EXPOSE THIS APPLI- ANCE TO RAIN OR MOISTURE. THE APPLIANCE SHALL NOT BE EXPOSED TO DRIPPING OR SPLASHING. NO OBJECTS FILLED WITH LIQUIDS SHALL BE PLACED ON THE APPLIANCE.
TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER OR BACK. NO USER-SERVICEABLE PARTS INSIDE. REFER SERVICING TO AUTHO- RIZED SERVICE PERSONNEL.
CAUTION:
IMPORTANT: READ ALL OF THESE INSTRUCTIONS BEFORE YOU INSTALL OR OPERATE YOUR SUBWOOFER AND SAVE THESE INSTRUCTIONS FOR LATER USE.
1. Read Instructions — All these safety and operating instructions should be read before you operate the unit.
2. Retain Instructions — These safety and operating instructions should be retained for future reference.
3. Heed Warnings — All warnings on the unit and in the operating instructions should be adhered to.
4. Follow Instructions — All operating and use instructions should be followed.
5. Water and Moisture — The unit should not be used near water — for example, near a bathtub, washbowl, kitchen sink, in a wet basement, or near a swimmingpool, etc.
6. Carts and Stands — The unit should be used only with a cart or stand that is recommended by the manufacturer. A unit and cart combination should be moved with care. Quick stops, excessive force, and uneven surfaces may cause the unit and cart combination to overturn.
7. CAUTION: To prevent electric shock, do not use the subwoofer’s polarized plug with an extension cord, receptacle, or other outlets unless the blades can be fully inserted to prevent blade exposure.
10. Power Sources — The unit should be connected to a
power supply only of the type described in the operating instructions or as marked on the unit.
11. Accessories and Attachments — Only use accessories and attachments specied by the manufacturer.
12. Grounding or Polarization — Precautions should be taken so that the grounding or polarization means of the unit is not defeated.
13. Power Cord Protection — Power cords should be routed so that they are not likely to be walked on or pinched by items placed upon or against them, paying particular attention to cords at plugs, convenience receptacles, and the point where they exit from the controller.
14. Cleaning — The unit should be cleaned only as recommended by the manufacturer.
15. Non-Use Periods — The power cord of the unit should be unplugged from the outlet when left unused for a long period of time.
16. Object and Liquid Entry — Care should be taken so that objects do not fall and liquids are not spilled into the enclosure through openings.
17. Damage Requiring Service — The unit should be serviced by qualied service personnel when:
• The power cord or the plug has been damaged.
• Objects have fallen or liquid has been spilled into the unit.
8. Ventilation — The unit should be situated so that its location or position does not interfere with its proper ventilation. For example, the unit should not be placed in a built-in installation, such as a bookcase or cabinet, that may impede the ow of air over the back plate.
9. Heat — The unit should be situated away from heat sources such as radiators, heat registers, stoves, or other appliances (including other audio components) that produce heat.
In accordance with the European Union WEEE (Waste Electrical and Electronic Equipment) directive eective August 13, 2005, we would like to notify you that this product may contain regulated materials which upon disposal, according to the WEEE directive, require special reuse and recycling processing. For this reason Sonance has arranged with our distributors in European Union member nations to collect and recycle this product at no cost to you. To nd your local distributor please contact the dealer from whom you purchased this product. Please note, only this product itself falls under the WEEE directive. When disposing of packaging and other related shipping materials we encourage you to recycle these items through the normal channels.
• The unit has been exposed to rain.
• The unit does not appear to operate normally or exhibits a marked change in performance.
• The unit has been dropped or the enclosure damaged.
18. Servicing — The user should not attempt to service the unit beyond that described in the operating instructions. All other servicing should be referred to qualied service personnel.
D8 Subwoofer
Tested to comply
with FCC Standards for
home or oce use only.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference
(2) This device must accept any interference received, including interference that may cause undesired operation.
Loading...
+ 3 hidden pages