Synchroniz ed Chuff pickup installation
with original equipment Hall Effect sensor
Some st eam locomotives are equipped with a round magnet mounted on an axle wit h a sensor to read
t he rotation of the magnet. The drawings below are for use with the original equipped Lionel® hall effect
sensor. While modifications to the main board are shown, they do void warranty.
LocoMatic™ Type 4 Sou nd & Control System synchronization wiring
Long edge of Locomatic™
Control Board
For the Hall Effect sensor to operate best, short R22.This must be
done with a small pencil soldering iron and great care as to not
damage the board. You can try it's operation firs t without doing
this but it may be necessary to do so.
RED
BLACK
GREEN
YELLOW
Sensor wires from
Lionel® pcbd.
SYNC input
see page 7 of main
instruction sheet
for full details.
GREEN
BLUE
L ocoMatic™ Typ e 3 Sound & Control System synchr onization wiring
For the Hall Effect sensor to operate best, short R25.This must be done with a
s mall pencil soldering iron and great c are as to not damage the board. You
c an try it's operation first without doing this but it may be necessary to do so.
RED
BLACK
GREEN
YELLOW
Sensor wires from
Lionel® pcbd.
SYNC input
see page 7 of main
instruction sheet
for full details.
WHITE
BLUE
246 W. Main St.
Leola, PA 17540
(717) 661-7041
Loading...