Da-Lite Model B with CSR User Manual

INSTRUCTION BOOK FOR

Model B® With CSR

(Controlled Screen Return)

Installation

Built-In-Hangers

Care in mounting and care in correct operation will mean a long
and satisfactory life for your Da-Lite wall/ceiling screen. Locate
the screen where the audience can best see it and where other
furnishings in the room permit. Mount the screen so that bottom
of picture surface, when fully extended, will be above the heads
of viewers.

Protect Your Screen by keeping it rolled in its protective case
when not in use. Always examine both front and back of surface
before re-rolling into case to make certain screen is free of dust,
dirt or other foreign matter. Use a very soft duster to gently
remove any foreign particles.

Da-Lite wall/ceiling screens may be mounted on a wall, map rail,
suspended from ceiling or extension brackets. Wall screens must
be mounted level and with the case-back parallel to the wall.

For Wall Mounting

Use the keyhole slot at the back of the hanging bracket for lush
wall suspension. Position screws or other fasteners into the wall
and hang screen by using the slots.

For Map Rail Mounting

Use keyhole slots in lat brackets. Do not use “D” rings.

For Ceiling Suspension

If the screen is to be ceiling mounted, two screw hooks should
be placed in a beam or other solid surface. For drop ceilings,
Da-Lite’s TBar Clips may be purchased.

For
Ceiling

For
Wall

2

Operating Instructions

To Lower Picture Surface

Pull screen down all the way. HESITATE – then allow screen to retract VERY SLOWLY until it locks in place.

To Raise Picture Surface

Pull down on the pull bail, then release quickly. The screen will retract
gently into the case.

To Adjust Retraction Speed

Use a large lat screwdriver to turn the adjustment knob on the right
end of the screen. To increase the travel speed turn counterclockwise.
To decrease the travel speed turn clockwise. Adjustments should be
made in half turn increments and travel speed checked before
adjusting further.

NOTE: This feature is not available on some large screen sizes.
Call the factory for adjustment instructions.

If screen locks at the bottom and will not retract, turn adjustment
knob one quarter turn counterclockwise.

Screen Accessories

Wall Brackets (75# Per Pair Maximum)

Da-Lite No. 6 and No. 11 Non-adjustable wall brackets and
No. 23 adjustable extension wall brackets are ideal for keystone
elimination, clearance, or corner mounting. The screen
brackets should be fastened to the studding or other
solid surface and not in the plaster only. Suspend
screen from “D” rings.

T-Bar Clip
For Dropped Ceilings

50 lb. max. load capacity.

No. 23 Adjustable
Wall Brackets

Screen can be extended 10", 14",
15 3⁄4", 18 1⁄4", 20" or 24" from wall
by wing nut and bolt`
adjustment.

No. 11 Wall Brackets

Screen can be extended
10" or 14" from wall by
changing position
of bracket.

No. 6 Wall Brackets

Screen can be extended
6" from wall.

Tilt Lock
For Keystone Elimination

Holds back bottom of
screen in tilted position
to eliminate keystoning.

3

LIMITED ONE YEAR WARRANTY ON DA-LITE PRESENTATION PRODUCTS

Milestone AV Technologies LLC warrants certain Da-Lite branded products to the original purchaser only, to be free from defects in
materials and workmanship for a period of one (1) year from the date of purchase by the original purchaser; provided they are properly
operated according to Da-Lite's instructions and are not damaged due to improper handling or treatment after shipment from the
factory.

This warranty does not apply to equipment showing evidence of misuse, abuse or accidental damage, or which has been tampered
with or repaired by a person other than authorized Da-Lite personnel.

Da-Lite’s sole obligation under this warranty shall be to repair or to replace (at Da-Lite’s option) the defective part of the merchandise.
Returns for service should be made to your Da-Lite dealer. If it is necessary for the dealer to return the screen or part to Da-Lite,
transportation expenses to and from Da-Lite are payable by the purchaser and Da-Lite is not responsible for damage in shipment.
To protect yourself against damage or loss in transit, insure the product and prepay all transportation expenses.

TO THE MAXIMUM EXTENT PERMITTED BY APPLICABLE LAW, THIS WARRANTY IS IN LIEU OF ALL OTHER WARRANTIES, EXPRESS
OR IMPLIED, INCLUDING WARRANTIES AS TO FITNESS FOR USE AND MERCHANTABILITY. Any implied warranties of itness for use,

or merchantability, that may be mandated by statute or rule of law are limited to the one (1) year warranty period. This warranty gives
you speciic legal rights, and you may also have other rights, which vary from state-to-state. TO THE MAXIMUM EXTENT PERMITTED

BY APPLICABLE LAW, NO LIABILITY IS ASSUMED FOR EXPENSES OR DAMAGES RESULTING FROM INTERRUPTION IN OPERATION
OF EQUIPMENT, OR FOR INCIDENTAL, DIRECT, OR CONSEQUENTIAL DAMAGES OF ANY NATURE.

In the event that there is a defect in materials or workmanship of a Da-Lite product, you may contact our Sales Partners at PO Box 137,
Warsaw, IN 465810137, (574) 2678101, (800) 6223737.

IMPORTANT: THIS WARRANTY SHALL NOT BE VALID AND DA-LITE BRANDED PRODUCTS SHALL NOT BE BOUND BY THIS
WARRANTY IF THE PRODUCT IS NOT OPERATED IN ACCORDANCE WITH THE DA-LITE WRITTEN INSTRUCTIONS.

Keep your sales receipt to prove the date of purchase and your original ownership.

A Milestone AV Technologies Brand

3100 North Detroit Street
Warsaw, Indiana 46582
P: 574.267.8101 or 800.622.3737
F: 574.267.7804 or 877.325.4832
E: [e-mail]
www.da-lite.com

DL–0280 01.14

© 2013 Milestone AV Technologies LLC. Printed in U.S.A.

85641