INSTRUCTION BOOK FOR
Fast-Fold® Truss Frame
Instructions
1. Unfold the 4 sections of truss frame, lock all latches and lay
face up on the loor.
2. Attach top and bottom sections to side sections using speedy
cranks. Observe color tapes so they match.
3. Unfold truss feet located in top and bottom truss sections
to raise frame of the loor.
NOTE 1: Frames have rivnuts at the hinge points on the top
and bottom sections. Insert a speedy crank through the
unthreaded rivnut and tighten into the threaded rivnut.
This will lock hinge joint securely.
NOTE 2: On screens 25' and over, another section of 6" truss
is provided. This section will mount on the top of the TOP
frame section and will appear to make an inverted “L”. “L”
section extends toward back of screen. Fasten top ”L” section
to TOP truss with speedy cranks. Observe color tapes so they
match. Flat steel diagonal braces are provided. These are
attached between the “L” section and the TOP truss frame
section. Tighten all speedy cranks securely.
Attach back braces to the BOTTOM section of the truss frame
section with speedy cranks. Observe color tapes so they
match. Tighten all speedy cranks securely.
4. Attach truss legs to side frame members at desired height,
using speedy cranks. Note color tape on legs and frame.
When matched, the screen height will be 44" of the loor.
If legs are too high, top section or sections may be folded
over. Do not tighten speedy cranks until all are started,
then tighten.
5. Lay the frame on the loor.
6. Match top of screen surface (labeled TOP) with top of frame.
7. Snap all four corners.
8. Starting at the bottom section, snap the center button.
Continue snapping the remaining buttons.
9. Attach Leg to each side of frame using at least 2 Speedy
Cranks per leg. NOTE: Speedy Crank at bottom of leg should
be on side of leg away from screen. Do not tighten Speedy
Cranks until all are started.
10. Height Adjustment. Fast-Fold® Truss screen height is
adjustable in 6" increments either up or down. Normal
screen height is 44" from bottom of frame to loor and
is the standard height for use with presentation
drapery accessories.
NOTE: Do not extend frame so that more than half of the
frame height is above the top of the legs.
11. Raise front foot of each leg and lock corner brace.
12. With one person at each leg, raise to standing position.
NOTE: With very large screens, more than 2 people may be
required.
13. Lower back foot, lock corner brace and attach”A” brace from
rear foot to back member of truss leg.
14. Attach anti-sway braces to legs.
15. To pack, reverse procedure. Use caution to prevent
surface damage.
2
Fast-Fold® Truss Frame Construction
Under 25' Wide
Left Side Of Truss
Frame Is Removed For
Better Viewing Of
Truss Leg
Make Sure Speedy
Crank Is Inserted
Through All Threaded
Hinge Joints
Truss Leg
ABrace
Detail Of Corner
Assy. Fasten Trusses
With Speedy Cranks
Anti-Sway Brace
(Mounted Insde When
Used Without Drapes)
Screen
Surface
Side Truss
Bottom Truss
Anti-Sway Brace
(Mounted Outside When Used
With Drapes)
Back Foot
25' And Wider
Left Side Of Truss
Frame Is Removed
For Better Viewing Of
Truss Leg
ABrace
Back Foot
Truss “L” Section
Make Sure Speedy Crank
Is Inserted Through All
Threaded Hinge Joints
Truss Leg
Truss Leg
Front Foot
Front Foot
Detail Of Corner
Assy. Fasten Trusses
With Speedy Cranks
Anti-Sway Brace
(Mounted Insde
When Used
Without Drapes)
Screen
Surface
Bottom Truss
Anti-Sway Brace
(Mounted Outside When
Used With Drapes)
Back Brace
Mounted To Bottom Of
Frame From Behind At
Hinge Locations With
(8) Speedy Cranks Each
Short Speedy Crank
Diagonal Brace
Short Speedy Crank
Assembled End View Of
Frame And "L" Section
Side Truss
3
LIMITED ONE YEAR WARRANTY ON DA-LITE PRESENTATION PRODUCTS
Milestone AV Technologies LLC warrants certain Da-Lite branded products to the original purchaser only, to be free from defects in
materials and workmanship for a period of one (1) year from the date of purchase by the original purchaser; provided they are properly
operated according to Da-Lite's instructions and are not damaged due to improper handling or treatment after shipment from the
factory.
This warranty does not apply to equipment showing evidence of misuse, abuse or accidental damage, or which has been tampered
with or repaired by a person other than authorized Da-Lite personnel.
Da-Lite’s sole obligation under this warranty shall be to repair or to replace (at Da-Lite’s option) the defective part of the merchandise.
Returns for service should be made to your Da-Lite dealer. If it is necessary for the dealer to return the screen or part to Da-Lite,
transportation expenses to and from Da-Lite are payable by the purchaser and Da-Lite is not responsible for damage in shipment.
To protect yourself against damage or loss in transit, insure the product and prepay all transportation expenses.
TO THE MAXIMUM EXTENT PERMITTED BY APPLICABLE LAW, THIS WARRANTY IS IN LIEU OF ALL OTHER WARRANTIES, EXPRESS
OR IMPLIED, INCLUDING WARRANTIES AS TO FITNESS FOR USE AND MERCHANTABILITY. Any implied warranties of itness for use,
or merchantability, that may be mandated by statute or rule of law are limited to the one (1) year warranty period. This warranty gives
you speciic legal rights, and you may also have other rights, which vary from state-to-state. TO THE MAXIMUM EXTENT PERMITTED
BY APPLICABLE LAW, NO LIABILITY IS ASSUMED FOR EXPENSES OR DAMAGES RESULTING FROM INTERRUPTION IN OPERATION
OF EQUIPMENT, OR FOR INCIDENTAL, DIRECT, OR CONSEQUENTIAL DAMAGES OF ANY NATURE.
In the event that there is a defect in materials or workmanship of a Da-Lite product, you may contact our Sales Partners at PO Box 137,
Warsaw, IN 465810137, (574) 2678101, (800) 6223737.
IMPORTANT: THIS WARRANTY SHALL NOT BE VALID AND DA-LITE BRANDED PRODUCTS SHALL NOT BE BOUND BY THIS
WARRANTY IF THE PRODUCT IS NOT OPERATED IN ACCORDANCE WITH THE DA-LITE WRITTEN INSTRUCTIONS.
Keep your sales receipt to prove the date of purchase and your original ownership.
A Milestone AV Technologies Brand
3100 North Detroit Street
Warsaw, Indiana 46582
P: 574.267.8101 or 800.622.3737
F: 574.267.7804 or 877.325.4832
E: info@da-lite.com
www.da-lite.com
DL–0257 01.14
© 2013 Milestone AV Technologies LLC. Printed in U.S.A.
47404
Loading...