Da-lite DESIGNER ELECTROL Instruction Book

The Da-Lite Difference.

Instruction Book for

DESIGNER ELECTROL®

3100 North Detroit Street
Post Office Box 137
Warsaw, Indiana 46581-0137
Phone: [phone]
800-622-3737
Fax: [phone]
Toll Free Fax: [phone]
www.da-lite.com
e-mail: [e-mail]

IMPORTANT SAFETY INSTRUCTIONS

When using your video equipment, basic safety precautions
should always be followed, including the following:

1. Read and understand all instructions before using.

2. Position the cord so that it will not be tripped over, pulled, or
contact hot surfaces.

3. If an extension cord is necessary, a cord with a current rat­ing at least equal to that of the appliance should be used.
Cords rated for less amperage than the appliance may over­heat.

4. To reduce the risk of electric shock, do not disassemble this
appliance. Contact an authorized service dealer when repair
work is required. Incorrect reassembly can cause electric
shock when the appliance is used subsequently.

5. The use of an accessory attachment not recommended by
the manufacturer may cause a risk of fire, electric shock, or
injury to persons.

SAVE THESE INSTRUCTIONS

1

PRE-INSTALLATION

Before proceeding with the installation of the screen, please read the installation and operations instructions thoroughly!

CAUTION! Do not cut wrapping paper or tape with knife or any sharp tool. Pull orange string.

!

s

1. Carefully unpack the screen and remove the outer wrapping.

2. Always handle screen in upright position.

3. Remove the front cover of the screen from the back of the screen. Lift front cover up approximately 1/2" and pull
away from back of screen. See Figure 1.

4. There are two methods of mounting the screen: suspended from ceiling and wall mounted. See Figure 2.

NOTE: Allow 1/2" above screen (when mounted) for front cover of screen installation and removal.

5. Picture surface is centered in case. Case extends 5-1/2" beyond surface on either end. Do not attach anything to
screen slat on the bottom of the screen.

HANGER BRACKET

“V” BAR MOUNTED
TO THE WALL

BACK OF
SCREEN

PICTURE SURFACE

SLAT

HANGER
PIN

FRONT
COVER

WALL

“V” BAR
MOUNTED TO
THE BACK OF
THE CASE AT
THE FACTORY

FIGURE 1 FIGURE 2

WALL MOUNTING

ALLOW A MINIMUM OF

1-1/4" FROM CEILING

CEILING

PICTURE
SURFACE

CEILING MOUNTING

PICTURE
SURFACE

PLACE “D”
RINGS OVER
HOOKS WELL
SECURED IN
CEILING.

2