INSTRUCTION BOOK FOR
Lectern
All Models
Optional Height Adjustment
Power
Connect power supply to 110/120 VAC 3-wire outlet
(220/240 VAC models to 220/240 VAC source).
Reading Light
Depress light switch to activate light. ADJUST VISOR AS
NECESSARY. Use GE 25T8DC 110v appliance lamp or equivalent
when relamping all 110/120 sound and non-sound lecterns;
GE 1176 12v for 220v lecterns.
Digital Clock/Count Down Timer
Select desired mode; adjust time with SET switch. Unit will
remain operational as long as the main power supply is on.
NOTE: Power interruptions will cause the clock to lash until reset.
Stacking Models
To remove lectern top from projector stand base, disconnect
power cord and turn the black knob (located under the middle
shelf) counter-clockwise until disengaged. Lift of lectern top and
place in desired location.
Models with optional reading surface adjustment are controlled
by the switch marked HEIGHT and provide up to 8 - 9 inches of
elevation. To raise or lower, depress HEIGHT switch.
Projector stand base features a 110/120 VAC Duplex receptacle
for equipment. Plug line cord into approved 3-wire 110/120 V
outlet. To assemble, reverse this procedure.
2
Sound Models
Plug microphone into shock mount on reading surface. Turn
main power switch located under reading surface on. Rotate
"MAIN MIC", "TREBLE" and "BASS" controls fully counterclockwise
to minimum volume position. Turn speaker switch located on
dash panel to "on" position. While speaking into the microphone,
slowly increase "Main Mic" volume by turning knob clockwise.
Adjust until feedback begins, then decrease volume to stable
condition or lower to desired volume level. Adjust bass and treble
controls to desired tonal quality. Turn SPEAKER SWITCH to "of"
position when done using the sound system.
Auxiliary Microphone (XLR Jack)
The auxiliary mic input is located under the reading surface and
is used for a second mic or wireless microphone input. The
volume control is located on the dash panel. The aux. mic input
is balanced low impedance (600 Ω) and is phantom powered so
condenser type microphone can be used.
Auxiliary Line Input (1/4" Phone Jack)
The auxiliary input is used for playback of tape
player, musical instrument, VCR, or an audio feed
from another sound system. The volume control
is located on dash panel.
Auxiliary Line Output (1/4" Phone Jack)
The signal output is a composite of all the inputs and can be fed
directly to an audio or video tape recorder. Or, the line output
can be fed to another sound system to combine systems for
greater output, or it may be fed to the input of a hearing
impaired system.
External Speaker Outputs (1/4" Phone Jack)
The external speaker outputs can be used to drive external
speakers in lieu of the internal lectern speaker. When a plug is
inserted into the external speaker jacks, the internal speaker is
disconnected. The powerful (50 watts) is adequate to drive
several speakers provided the total load impedance is not less
than 2 ohms. The output of the ampliier is self-protecting against
overload; however, low impedance loads (below 2 Ω) will cause
excessive heating reducing ampliier output.
Main MIC. AUX. MIC. AUX. Line Bass Treble
Speaker
On
Of
Up
Down
Service
The Da-Lite sound system is modular in design for ease of
service. The power supply and ampliier are accessed inside
the lectern body. The controls are accessed by removal of
dash panel.
If your lectern fails to operate on a known power source, be
sure to check the circuit breaker located on the Power Supply
for a tripped condition. Reset to restore function. If breaker
continues to trip, discontinue use of product until problem can
be diagnosed.
Height
On
Of
Light
Digital Clock-Timer
Minute
Hour
Set Mode
Clock
Timer
3
Lectern Wiring Diagram – Non-Sound System
Clock/Timer
Switch
Green
Blue
Orange
Brown
Yellow
Black
White
Red
Dash Panel
(Rear View)
Digital Clock
On
Of
On
Wire Code
Fast/Slow
Switch
T1
120 VAC
Only
(Optional)
Motor
Wire Nut
Conn. –3 CIR.
Height Adj.
Switch (Optional)
Conn.
3 CIR.
Conn.
3 CIR.
Light
Switch
120 VAC
Conn.
3 CIR.
Power
Supply
To Light
Conn. –2 CIR.
Wire Nut
220 VAC
(Optional)
4
Lectern Wiring Diagram – Sound System
Mic 1
Clock
Reading
Lamp
Speaker
Switch
Preamp/Mixer
Assembly
Dash Panel
Circuit Housing
Reading Lamp
Switch
Ribbon
Cable
AC Pug
117 Volts AC
External
Speakers
Motherboard
2020
11
110 – 230
Volts
50 – 60 Hz
Fused (10A)
Inlet
Power
Supply
Power
Amp
Circuit
Housing
Ampliier
Assembly
Line In
Line Out
Mic 2
Com
Full
AC
Out
SW.
High
3Pin
Jack
Power
Switch
+
Tweeter
+
Woofer
Sound System by AmpliVox®
5
6
7
LIMITED ONE YEAR WARRANTY ON DALITE PRESENTATION PRODUCTS
Milestone AV Technologies LLC warrants certain Da-Lite branded products to the original purchaser only, to be free from defects in
materials and workmanship for a period of one (1) year from the date of purchase by the original purchaser; provided they are properly
operated according to Da-Lite’s instructions and are not damaged due to improper handling or treatment after shipment from the
factory.
This warranty does not apply to equipment showing evidence of misuse, abuse or accidental damage, or which has been tampered
with or repaired by a person other than authorized Da-Lite personnel.
Da-Lite’s sole obligation under this warranty shall be to repair or to replace (at Da-Lite’s option) the defective part of the merchandise.
Returns for service should be made to your Da-Lite dealer. If it is necessary for the dealer to return the screen or part to Da-Lite,
transportation expenses to and from Da-Lite are payable by the purchaser and Da-Lite is not responsible for damage in shipment.
To protect yourself against damage or loss in transit, insure the product and prepay all transportation expenses.
TO THE MAXIMUM EXTENT PERMITTED BY APPLICABLE LAW, THIS WARRANTY IS IN LIEU OF ALL OTHER WARRANTIES, EXPRESS
OR IMPLIED, INCLUDING WARRANTIES AS TO FITNESS FOR USE AND MERCHANTABILITY. Any implied warranties of itness for use,
or merchantability, that may be mandated by statute or rule of law are limited to the one (1) year warranty period. This warranty gives
you speciic legal rights, and you may also have other rights, which vary from state-to-state. TO THE MAXIMUM EXTENT PERMITTED
BY APPLICABLE LAW, NO LIABILITY IS ASSUMED FOR EXPENSES OR DAMAGES RESULTING FROM INTERRUPTION IN OPERATION
OF EQUIPMENT, OR FOR INCIDENTAL, DIRECT, OR CONSEQUENTIAL DAMAGES OF ANY NATURE.
In the event that there is a defect in materials or workmanship of a Da-Lite product, you may contact our Sales Partners at PO Box 137,
Warsaw, IN 465810137, (574) 2678101, (800) 6223737.
IMPORTANT: THIS WARRANTY SHALL NOT BE VALID AND DALITE BRANDED PRODUCTS SHALL NOT BE BOUND BY THIS
WARRANTY IF THE PRODUCT IS NOT OPERATED IN ACCORDANCE WITH THE DALITE WRITTEN INSTRUCTIONS.
Keep your sales receipt to prove the date of purchase and your original ownership.
A Milestone AV Technologies Brand
3100 North Detroit Street
Warsaw, Indiana 46582
P: 574.267.8101 or 800.622.3737
F: 574.267.7804 or 877.325.4832
E: info@da-lite.com
www.da-lite.com
DL–0336 5.14
© 2014 Milestone AV Technologies LLC. Printed in U.S.A.
75862
Loading...