Da-Lite 88630N Instructions
INSTRUCTION BOOK FOR
Fast-Fold® Deluxe
Screen Frames
Standard Leg
Procedure
Da-Lite Fast-Fold® Deluxe frames are made of 11/4” square hard aluminum tubing with an anodized inish. With proper care they will
provide many years of use. Please follow the set up instructions below (steps 16).
1. Remove the frame from its case and wrapping. Position it as shown (front view).
Two Section Frame Three Section Frame
2. Unfold the frame following the directions given below so that it is lying lat, snap latches will automatically lock.
Looking From The Top
Top
Rotate 90
o
2
Procedure
3. While holding the bottom of the frame in place, lift the top
of the frame to unfold the sides. Lock down all four
corner braces.
4. Lay the frame on the loor.
5. Match top of screen surface (labeled TOP) with top of frame.
6. Snap all four corners.
7. Starting at the bottom section, snap the center button.
Continue snapping the remaining buttons.
8. Snap the top and sides in the same manner.
9. Attach Leg to each side of frame using at least 2 Speedy
Cranks per leg. NOTE: Speedy Crank at bottom of leg should
be on side of leg away from screen. Do not tighten Speedy
Cranks until all are started.
Screens under 10' in height will include
6 Speedy Cranks (3 per leg).
Screens 10' in height and over will include
8 Speedy Cranks (4 per leg).
Any screen ordered with optional HD Legs will include
10 Speedy Cranks (5 per leg).
10. Height Adjustment. Fast-Fold® Deluxe screen height is
adjustable in 6" increments either up or down. Normal
screen height is 44" from bottom of frame to loor and
is the standard height for use with presentation
drapery accessories.
11. To fold frame, unlock all four corner braces. Push
the blue snap latch buttons and fold the frame.
NOTE: for some frames fold the top and bottom irst.
Top
Snap Latch
Snap Latch
Lock Down
The Corners
Leg
Frame
NOTE: Do not extend frame so that more than half
of the frame height is above the top of the legs.
Blue Snap Latch Button
Speedy
Crank
Frame
Spacer
3
Loading...