Da-Lite 24397 Instructions
INSTRUCTION BOOK FOR
UTB Contour
Large Wall Bracket (47”)
(1) Screens under 104" in viewing width
(2) Screens 104" and over in viewing width
Tools Required for InstallationIncluded Hardware
Small Bottom Wall bracket (8”)
(1) Screens under 104" in viewing width
Large Bottom Wall bracket (44”)
(1) Screens 104" and over in viewing width
Frame Brackets
(1) Screens under 104" in viewing width
(2) Screens 104" and over in viewing width
Phillips Screwdriver
Tape Measure
Pencil
#10
X ⅜"
Silver Screws (12) 832
#10
X ⅜"
Pointed
Black Screws (Varies)
2
X ⅜"
Machine Screws (4)
832 X ½" Fillister Screw
(1) Screens under 104" in viewing width
(2) Screens 104" and over in viewing width
Inner Frame & Viewing Surface Assembly
1. Create a clean work area for assembly using a soft clean material.
This will protect the inner frame and ensure a clean projection
surface.
2. Unwrap frame pieces. Assemble inner frame pieces on the work
area.
3. Slide inner frame pieces together at corners. Secure inner frame
pieces with (12) #10 x
4. Set the assembled inner frame aside. Unroll screen surface and
place it viewing side down on the clean work area.
5. Place inner frame on screen surface, screw side up.
⅜
" silver screws (Figure 1).
(12) #10 x ⅜" Screws.
Silver, Flat Tip
6. Wrap fabric around inner frame and hook grommets over the
corner pins (Figure 2).
7. Hook the rest of the grommets over the lat head screws on all
sides (Figure 2). Please be sure the grommets clear the head of
each screw.
Note: Your screen was assembled and aligned prior to shipment.
If any realignment is necessary, the positioning of the lat head
screws can be adjusted. Using a Phillips screwdriver, rotate the
lat head screw one turn counterclockwise. Reposition screw as
needed. Secure the screw in place by slowly rotating it clockwise.
Grommets
Corner
Pin
Grommet is under
the Flat Head Screw
Figure 1
Flat Head
Screw
Figure 2
3
Loading...