Dakota Digital LAT-NR350 User Manual

MAN#650204

Kit Includes:

Installation:

INSTALLATION INSTRUCTIONS

LAT-NR350

LED Tail Lights for 1964-1966 Mustang

1. Remove both right and left tail light lenses as described below at the same time, taking care to
keep the left and right lenses and trim with the correct side of the vehicle.

2. Remove the four screws that hold the chrome tail light trim piece.

3. Remove the tail light trim piece and the lens.

4. Remove the light bulb from socket.

5. Loosen the lens seal from the housing by gently pulling the seal away from the housing.

6. Now is a good time to clean the lenses and the tail light housings. If the lenses are in poor
condition a replacement set is recommended.

7. Make sure the housings and lenses are clean and dry. DO NOT remove backing from tape yet!
Place the light diffuser onto the back of the lens. Check for proper fitment of diffuser to inside
of lens and note the places where the tape touches the lens.

MAN#650204

8. DO NOT remove the backing from the tape yet! Place the LED assembly in the housing. The
wide black bar on the wire side of the LED assembly is marked to show which end of the
assembly should be up. Note the places where the tape touches the housing.

9. Squeeze the primer tube to break the glass bulb and wet the brush end with primer. Rub the
primer on the lenses and the housings at the places where the tape will touch. Treat both left
and right housings and lenses at the same time before the primer tube dries out.

10. Wait for 5 minutes for the primer to dry and cure.

11. Remove the backing from the tape on the diffuser and place diffuser onto lens.

12. Insert the bulb base from the LED assembly into the bulb socket. Test the tail and brake lamps
to make sure they work as expected before going on.

13. Remove the backing from the tape on the LED assembly and insert assembly into the tail light
housing keeping the assembly centered in housing. Make sure the arrow is still pointing up.
Press firmly on the bracket to ensure good tape bonding.

14. Place lens gasket onto housing and reinstall the tail light lens and trim piece. Secure with the
trim piece screws.

MAN#650204