Dakota Digital LAT-NR310 User Manual

INSTALLATION INSTRUCTIONS

LAT-NR310

LED Tail Lights for 1969 Chevelle

MAN#650207

Kit includes:

Installation:

1. Remove the tail light housing from the vehicle.

2. Remove the bulb connector from the back of the housing.

3. Remove the 4 screws that hold the trim and lens. Remove the trim and tail light lens from the
tail light housing.

4. Now is a good time to clean or replace the lens and housing if necessary.

5. Note that there are two different LED assemblies. One for the driver side and one for the
passenger side. Select the correct assembly for the tail light housing. Remove the two locking
nuts and flat aluminum plate from the back of the new LED assembly.

Left or driver’s
side LED assembly.

Right or passenger’s
side LED assembly.

6. Insert each new LED assembly through the hole where the original bulb and connector were.
Use caution when feeding the wires through to avoid damaging the wire insulation.

7. Feed the wires through the large hole in the back plate and attach the back plate onto the back
side of the housing. The flat side of the mounting disk should be toward the outside and the
side with the slight raised center should go in toward the housing. This will index the mount in
the original housing.

8. Secure the LED assembly into the housing with the supplied plate and nuts.