Dakota Digital LAT-NR230 User Manual

MAN#650188

Kit Includes:

Installation:

1. Remove the two screws and tail light lens.

INSTALLATION INSTRUCTIONS

LAT-NR230

LED Tail Lights for 1960-1972 Chevy Fleetside Pickup

2. Remove the light bulb.

3. Push and twist to remove the plastic wire socket from the back side of the housing.

4. Now is a good time to clean the lens and housing. If lenses are in bad shape a new set is
recommended.

5. Remove the nut and round metal spacer from the back of the new LED assembly.

MAN#650188

6. Insert the new LED assembly through the hole where the original bulb and connector were.
Use caution when feeding the wires through to avoid damaging the wire insulation.

7. Feed the wires through the round metal spacer, with one wire going through each outer hole in
the aluminum spacer. The larger diameter ring should be away from the tail light housing. Use
caution when feeding the wires through to avoid damaging the wire insulation.

8. Secure the metal spacer with the supplied #6 nut.

9. Place the original lens gasket into place and replace the tail light lens. Tighten the screws
down carefully.

MAN#650188